Wireless

I have four separate AP1200's on different ethernet segments that seem to hang after several hours. Sometimes the status led only is lit solid...no eth or radio activity. Sometimes no led is lit however the ethernet port at the switch it's plugged in...

I need to Know how to control the traffic in a bridge???Someone has any idea??Thanks

HiDownload the ACU of the Web, nevertheless this application presents/displays errors at the time of exec. as I can obtain a disc of this software or one version previous? thanks for the aidantecedents: I´m Wireless LAN SEs and FEs

I've been tasked with looking into wireless connectivity from our main campus to several buildings various distances away. I'm confused by the antenna choices when it comes to maximizing throughput to these locations.The buildings that are "across th...

My questions stem from Cisco's literature (and almost all other wireless AP manufacturers') where Load Balancing by the AP is mentioned. By placing 2 or 3 APs in the same cell on different channels, the theory is that the beacons/advertisements from ...

Hello,COULD YOU EXPLAIN THE CONCEPT OF LINE OF SIGHT .IS THIS INCLUDE FRESNEL ZONE AND EARTH BULGE .THANKS A LOT.REGARDSJACQUES

hi all,I would like to have an aproximation to the "most sold" wireless outdoorproducts. I mean, the ones who allow you to connect two or more buildingsand in the same time have can act as Access Point.Thanks

i need to suggest to a customer a voice solution over wireless links. The network configuration is as below:one central site with 3662 router & 9 remote sites with 1750. all the routers are equipped with voice ports. The central site is connected to ...

PROBLEM/QUESTION Users are currently authenticated by an ACS server when remotely accessing the network through a VPN. So their user accounts have been created and there is currently no value for [027]Session-Timeout RADIUS attribute. What will happe...

I have to install Aironet 350 wireless bridge, but the distance between anteena and bridge will be more then 75metre (due to some LOS issues at site) so how can I have low loss cable of 75m when from Cisco, maximum 150ft cable is available??

When inserted Intel wireless 5000 cardbus into Cisco 1200 access point emty slot, 1200AP has reloaded, but not find new hardware. Perhaps, third vendors 802.11a cards can not use in Cisco Ap's? And we must wait Cisco hardware releases?

I have been tasked to install some Cisco Aironet 350 Access Points. We are utilizing our Raduis server for authentication at a site connected via 3MB WAN.I've been told that I can only have 3 access points at our site because of site survey that was ...

How many antennas needed for the 350 series access pioint ( AIR-AP352E2R-A-K9 ) ?Can we connect the antenna AIR-ANT4941 directly to the aboce access point ?

can lightning arrestor handle a direct lightning strike and discharge this energy to a properly installed earth ground?

what's the relation between Gain and transmitted power with coverage area?if we want add coverage area, could we just add antenna's gain only or add transmitted power only?