Hello,We moved to a new public CA and I am trying to add a new certificate but everytime I issue the commands, ip http secure-trustpoint TRUSTPOINT-2025no ip http secure-serverip http secure-serverI can no longer get into the webpage, I have to put t...
Did now AIR CAP-3502E-C-K9 can be fully autonomous or still limited to Site survey mode only?
Good day,I have been running into several issues after upgrading the software on my catalyst 9120 AP that came with ewc version 17.6.4.I upgraded the version via the http option on the GUI, and after I did, I could not reach the management interface ...
I have Cisco Catalyst 9800-CL Wireless controller and Sonicwall Firewall Nsa4700 sonicos 7.0I need to implement Guest wifi in my campus. WLC should show ssid it should redirect to sonicwall, it should authenticate guest users i have created in local ...
Can I create a SSID for multiple networks using template?If so, what are the things I need to be careful about? Like if I map the networks to the new template, will the networks lose any existing configuration?
Hello Cisco WLAN experts,I found recommendations in this forum to reload Cisco APs in front of a SW-upgrade or on a regular basis to avoid problems on certain SW-versions of the 9800-80-WLC and 9130 / 3800 / 2800 APs.Now I found out that the Cisco IO...
I'm new to cisco and want to bought Air CAP1602i-C-K9 as an autonomous/Standalone Access point into my house but I'm still puzzlef about this:- Can it be converted into Standalone firmware? - Did this CAP1602i Led indicator has single led color which...
Hi, On this AP model, its already known in the manual book for lightweight mode. But what happen when on autonomous mode? Did the LED indicator meaning still same? (Like blinking green at boot, amber after that, then join/discovery with cycling green...
Hey all, I recently bought myself a smart thermostat with valves. I am having trouble to set the devices up with wifi (Using an MR33). besides the bridge for thread and matter devices the rest just wont connect. Using the same equipement in another w...
Hi all,We’re evaluating Meraki Dashboard for mixed environments and I’m trying to understand the scope of Guided RCA. Does Meraki’s Guided Root Cause Analysis work only with Meraki MS switches as mentioned in the screenshot below?If we onboard Cataly...
Hi community,does someone has tested or using a combination of CW9172I + IPv6 + named VLAN + MR 32.1.5 .In my setup I can't get an IPv6 address via DHCP with my SSID configured in bridge mode with using named vlan.If I use the VLAN ID it works well.W...
We are currently testing Cisco ISE for 802.1x wireless authentication.When it uses the default port 1700 on both the ISE and SSID, it fails with an ISE log message of11052 Authentication request dropped due to unsupported port number.I can see in Wir...
Hello, do MR44 APs need to see each other over the LAN management or do they only need Internet access to contact the Meraki cloud?
HeyI've been trying to lab a couple of things today, one of them being Wireless Trusted Access. Since Meraki now supports Entra ID integration, it's possible to use Entra and IdP for the Wireless Trusted Access.After working through a combination of ...
We have a couple rooms with exposed truss ceilings. Our old APs have their brackets wire-tied to the bottom of the truss. Does anyone have any better suggestions for mounting the Meraki MR44 to this type of ceiling?
