how to configure a Cisco air-cap-3602l-a-k9 to connect to a Comcast router, how to get the GUI configuration tool?
Forum Posts
So behind the "cryptic" Title is the following scenario APs in localmode, but since we need to "pick up" some wired mDNS services on sites, one AP at a site is configured as an mDNS-AP (with the proper VLAN and so on).Great. - So far so good. BUT the...
I'm trying to upgrade a C9800-L-F controller from 17.3.3 to 17.3.4c using ISSU.The controller hardware is:cisco C9800-L-F-K9 (KATAR) processor (revision KATAR) with 1702951K/6147K bytes of memory.The software I'm using is:C9800-L-universalk9_wlc.17.0...
I have an interesting observation that I would like community feedback on.Use-case: Cisco 5520 WLC + 1562E RAP + Locally switched SSID According to Cisco design guide, enabling the global option "Backhaul Client Access" on WLC will allow wireless cli...
Resolved! Cisco AP "Bridge"
Good Day, Have a Mikrotik Bridge (AP) connected to the client's WLC. (Static Bridge IP & PSK Configured On Mikrotik) Printer connects via Ethernet to Bridge (Static IP on Printer) Looking to replace the Mikrotik's with Cisco equivalent(s) Asking for ...
How does everyone do their AP / RF grouping for large corporate buildings? Do you do by floor? By wing? etc.
Hi Team, i like to change the AP Mode from CAPWAP to eWLC on 9105w to perform a Site Survey. I upgraded and converted in every known fashion, following the Guides, but the command "ap-type ewc..." is still not available, in no . Now the AP is associa...
Hi all,we have 2x WLC 9800 physical/virtual in HA and notice occasionally switch to/from WLC1 to WLC2, which causes short connection interruption while all APs go to the other WLC.we did upgrade to 17.3.4c from 17.3.2a - same issueios same on both WL...
Hi,Our deployment is currently composed by:- Catalyst 9800-40 release Amsterdam 17.3.3 (upgrade performed from the default version 16.12.02s) - Access Point 9120AXWe are not allowed to configure the helper address on the Gateway (Firewall Checkpoint)...
Hi Gentsi have 17.3.3 C9800 + Nx flexconnect-mode C9120AXI-E APs deployment with couple of locally switched SSIDs set for their clients AAA up against ISE. Everything works as expected with exception: APs send accounting requests to ISE for their cli...
Hi,Can you help me with this issue:It is required to configure an external dhcp in the Anchor controller for wireless guest users. The Anchor controller is in the DMZ and the external server is on the internal network. Can someone tell me how to conf...
There is a user in my company that is receiving constant lockout, after investigating there is a device that is using his username to try and authenticate but wrong password to our wireless meraki. We can not locate the device we only have the MAC th...
Hi all! I am thinking of getting a Cisco Aironet 1830 for my small home-lab (is the smallest that I've read that supports Cisco Mobility Express and its compatible with the WLC9800-CL), my purpose is just to learn how to setup and deploy this techno...
I am trying to take the list of AP's of WLC cisco device. I got below oid from the document. But these oid list only the AP's are UP. So when we get the list the AP's which are down are not shown in the list using the below oid. Is there any oid whic...
I fill up login details but shows the invalid username and password.what should I do
