Using OpenDNS on cellular network

I'd like to be able to get the same protections from OpenDNS when I'm out and about, on the cellular network.  Can I do this by running the OpenDNS update app on my phone, and pointing my phone's DNS to the two OpenDNS name serverss?  Or is that poss...

CML 2.8: SD-WAN Manager 20 is not in sync with the licenses in CSSM

I have deployed an SDWAN lab using sdwan-lab-deployment-tool for 20.15.1 version devices on CML 2.8. The CML instance is registered and showing as Registration Status:Registered and License Authorization Status:Authorized, with a Learning@Cisco smart...

REP Implementation - Ring within a Ring

I am pretty sure I know the answer to this, but I am looking for a bit of guidance.  I have an industrial plant with many switches, they are currently using STP for their loop prevention protocol and we are recommending that they implement REP for fa...

Issue in Genie parser for commands "show ip mroute summary vrf <name>"

Im running into a unique issue with the genie parser for the command show ip mroute summary vrf vrf_captain_america. The same parser works fine on my Nexus switches that are not part of the vxlan fabric, and I get the parsed output correctly.However,...

DNS IP update in ISE

Hi Everyone We are in ISE 3.3 version. Is it possible to remove all DNS servers with single 'no ip name server dns ip 1 dns ip2 dns ip3' or do we need to remove DNS IPs one by one? Can we remove all 3 with single no command and add 3 IPs again with a...

Cisco 4351 with three ports and one connects to the internet.

I am recently retired from IT, with NO routing experience, so don't be surprised if I say something anything that is incorrect. I'm working on a home lab to isolate my experimentation from the rest of the house and I have a problem - my Cisco 4351 ha...

Accessibility status

Hello. Accessibility has become an important issue here at NYU. I recently inquired with Duo support on this topic, especially as a year ago Duo posted that work was underway toward WCAG 2.0 compliance. Support indicated that the Duo admin panel ...

ISE Netscaler Loadbalancing Cross-Service Persistence

Hi everyone,I'm following this guide for my setup: https://community.cisco.com/t5/security-knowledge-base/citrix-netscaler-cli-configuration-for-cisco-ise-radius-and/ta-p/4679861#toc-hId-279038066I also checked this discussion about radius persistenc...

9300L upgrade path from 17.06.05 to 17.12.04

We tried to do a direct upgrade from 17.06.05 to 17.12.04 and received the errors below.The switch is still on the older version.This is the command I used:install add file usbflash0:cat9k_lite_iosxe.17.12.04.SPA.bin activate commitPWSWCO01#dir flash...

Looking for NetFlow Analyzer with Post-NAT Destination IP Reporting

Hello,I am looking for a NetFlow analyzer that can display and report statistics using the Post-NAT Destination IPv4 Address.For example, I’d like to monitor the download traffic of each individual end host based on their internal LAN IP addresses. H...

Dual ISP on single FDM

Hello,My setup is a Cisco Firepower 1120 FTD version 7.6.2.1-3  (FDM). We have 2 ISP outside interfaces. For this we'll name them ISP-A and ISP-B. So currently we have our default internet traffic as well as VPN going through ISP-A. We want to make i...

Switch 9300 stuck ROMMON

After Factory reset I install system from TFTP server.Now switch stuck in rommon after reebotPlatform C9300LPLATFORM_TYPE C9300L speed 9600Booting Recovery Image 16.12.1 Initiating Emergency Installation of bundle tftp:///cat9k_iosxe.17.18.01.SPA.bin...

FCW2232L0V3

Diferencia estado operacional y administrativo de una interfaz

The Strangest Wireless Network Issue!!!

Hi teachers, I have recently encountered a strange issue. During the normal use of our wireless network, there will suddenly be a loss of Internet connectivity. If I then click to disconnect and try to reconnect to the same WIFI, it will keep showing...