Buy or Renew
Buy or Renew
Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
2114121members
1452472discussions

Trending Topics

Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!

Community Activity

Start a conversation

N7K replacement

HiWe are looking for recommendations for replacing our existing N7K.Is someone able to guide us in the right direction...This is the current build:Mod  Ports  Module-Type                         Model              Status---  -----  ------------------...

Redbeanie by • Level 1
  • 862 Views
  • 7 replies
  • 0 Helpful votes

Resolved! Can not get Internet Access [or nat translations] on my ISRC1111

Hello   I am working multiple setups but this one was supposed to be easy, until it was not. I am sure I am overlooking something tiny, but nevertheless. Long story short; here is my config and I get not get any NAT translations and or any internet a...

TheGoob by • VIP
  • 623 Views
  • 30 replies
  • 0 Helpful votes

pvlan community on trunk to server

I have pvlan trunk port facing router with some pvlans, primary and isolated vlans. I also have access (community) and trunks with isolated ports and this all works ok. Problem is that I need to have trunk port facing host that utilize normlal and co...

LED flashing Cisco 2802i

I have Cisco 2802i-e-k9 and after boot its flashing Green,blue,red slowly and it doesn't broadcast ssid. What is the problém? 

TRIXIK by • Level 1
  • 140 Views
  • 3 replies
  • 0 Helpful votes

Isolated VLAN That Requires Internet Access Only

I am looking to find out the proper configuration for three ports on two 3750X switches to have an isolated network / VLAN that will NOT talk to any other network / VLAN in my environment and only needs internet access. I have two interfaces on one s...

Eigrp Topology

I didn't understand the summarization part and how it's possible that only two routers R1 and R2 have the summarized route for R6's loopback??

SDA access

Hello i know now that fusion router not needed anymore. And border node can handle route leaking and other 1- but concern related to edge node, prefer to use 9300 or mow can use 9200b2- for management switch which will going to connect ISE and DNA an...

Mobility Express To 9800 Wireless LAN Controller

Hello,I am new to the Cisco Self Standing Wireless LAN Controller System. I have always used Mobility Express, and I know it is end of life. The purpose of this AP is for learning and using it in my home lab. I have read this post below:Migrate ME to...

Unable to ssh the FTD device

Dear Team, I unable to ssh the FTD device. No External authentication is configured. Local authentication enable. When ssh the device user name & password asking. After giving proper credentials access denied. But on same credentials we able to login...

suryaaa by • Spotlight
  • 217 Views
  • 6 replies
  • 0 Helpful votes

2960X image upgrade isse

greetings everyonethis is about an issue i am facing with my Cisco 2960x switches. i did a firmware upgrade from 152-7.E10 to 152-7.E11 image which currently is the recommended one.Unfortunately for some strange reason, after reboot the switch goes i...

Load more