Buy or Renew
Buy or Renew

Application Centric Infrastructure

Join the ACI conversation. Jump into this space for access to peers and industry experts. You’ll find the latest updates, helpful resources, and assistance when you need it.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Forum Posts

Start a conversation

ACI DHCP Relay

Hi, I have an EPG configured in a User Tenant with a requirement to access a DHCP server located Externally over a L3Out. The EPG and L3Out are both in the same Tenant-VRF. I have created a DHCP Relay Provider within the User Tenant with the EPG type...

iwearing by • Level 1
  • 2912 Views
  • 2 replies
  • 0 Helpful votes

ACI SNMP V3

Good afternoon, Are there any issues configuring ACI to use SNMP V3. The SNMP management station can poll the ACI APIC's when configured to use V2. However the APIC's do not respond to management polls when configured to use SNMP V2. Any help appreci...

iwearing by • Level 1
  • 3507 Views
  • 1 replies
  • 0 Helpful votes

Resolved! How to find ALL EPGs that assign to an interfaces or VMs Domain?

Hello Community, I think this feature has been requested somewhere, I hope to put more traction to Cisco Dev to provide an effective way to find ALL EPGs that an interface is associate with.   As we are moving from traditional network to ACI, the num...

Issue when upgrading APIC

Hello everyone, I recently started by upgrading my controller (APIC). Our target was the 2.0.2f and there was initally the 1.1.3f on our hardware. So as we've seen from cisco, we needed to go through the 1.2.3 before trying to reach the target. (2.0...

compterds by • Level 1
  • 3241 Views
  • 5 replies
  • 0 Helpful votes

Resolved! Failure tolerance in ACI

I have a question about the failure tolerance in ACI. My setup are 3 leafs and 2 spines. Usually its ok if one link is dead because the leaf would use the other spine.Attached to this discussion is an example that shows two endpoints which are trying...

jwendling by • Level 1
  • 867 Views
  • 1 replies
  • 0 Helpful votes

ACI L3out with SVIs

HiWe've got 2 ACI fabrics (not linked) and are now nearing the end of the migration of services from our old Cat6500 DC switches to ACI. One ACI fabric is in our main DC, the second is in other backup DC (although a couple of live servers do run ther...

Andrew C by • Level 1
  • 6624 Views
  • 6 replies
  • 0 Helpful votes

Tunnel Interfaces - ACI

I have 4 Spine switches and 16 leaf switches in my ACI environment Under the Fabric, below each node, (Spine or Leaf) I could see a number of tunnel Interfaces configured. When I check the EPG Information of a specific server under the Fabric Inven...

Load more

Review Cisco Networking for a $25 gift card

Save 25% on Day-2 Operations Add-On License