Can I specify a timeout value for the sticky layer4payload,will the timeout value work for this stickyI was unable to find the documentation on this.Please advise me
Hi,We replaced a WAE-474 yesterday. After the installation of the new device, I recovered the running-config for this device from WAAS CM. Unfortunately, SSH service is not enabled on the new device and at the same time telnet is also disabled.The d...
Our Exchange 2010 hub servers run multiple services/ports: smtp, www, pop3,135, 143, https, 993, 995, 6001,6002,6003,60200,60201,8400, and 8402what is the best way of balancing these servers so that if only one of the services failed on a server, it...
Here is what I need to do.I have a web application that requires HTTPS. However, I'm told by the vendor that we need to use a cookie for sticky.Based on what I've read, for cookie sticky to work with HTTPS, the ACE needs to perform SSL offload.Howev...
Hi,I have an HA ACE deployment and all seemed to be working well until I tried to access the ACE via the management VLAN in the one non-system context, no go.The ACE is in one-armed mode with an Admin/System context and one user context (named Messag...
I am trying to upgrade a DCNM Linux installation and I can't get DCNM to stop to perform the upgrade.I have tried to stop it using both normal user and root but I get the following message:[netops@dcnm1 init.d]$ ./jboss stopJBOSS_CMD_START = cd /usr/...
Hi:Desperately looking for some help here and thanks in advance for reading.I have been migrating a lot of serverfarms from the CSM to an ACE environment successfully so far and now I am at the last step where I am migrating a serverfarm from a CSM e...
We're trying to understand how "match http content ...." works. We're trying to match this:http://www.acme.com/widgets/stories.aspx?section=prodlist1&promo=specialWe've coded this:class-map type http loadbalance match-all redirect_to_prod_site 10 ma...
How can you force the ACE to use a strong cipher for remote management through an HTTPS session? After viewing an SSLScan of the admin interface, multiple 56 and 40 bit ciphers are being allowed...sslscan --no-failed 10.10.10.10 | grep -i accepted ...
We have deployed an ACE 4710 and its working perfectly. But the problem is that after I chage the default gateway of the servers I am not able to transfer files from one server to other. Is there any special configuration needs to be done on ACE to...
I first tried to back it up through the CM, but was getting errors in regards to the it failing while setting the remote directory. So i Putty'ed onto the individual wave and typed in the following:copy ftp virtual-blade 1 disk 1 192.x.x.x(ftp serve...
