Application Networking

we have two Nexus 9k and vpc is running, peer-keepalive link is going from mgmt port to mgmt switch, Peer-link is working on 4 ports 10g. I am confuse with sticky bit, i turned down the peer-keepalive link (no effect on peer-link) then i broke peer-l...

Has any one configured two central manager in one Core WAAS appliance

Hello all We are looking install a new data center core switch based on the Nexus 7700 platform, probably the 7702 or 7706. We do not require many features, just the classic OSPF, VRF-Lite, vPC, 4x VDC... Now I know in the past there were quite big d...

Our WCM is reporting 'SIA invalid packets are detected in service-node' on one of our WAEs (8541). This alarm appears in WCM for few minutes and then vanishes. When I check alarm's description on WCM it says the following: Details: The System Monitor...

We have a Cisco Nexus 9372PX unit, and  we try to insert 8 GLC-T without any success. The interfaces appear as: "is down (Link not connected)". We get connectivity using two old SFPs of the same model, the only difference that I see is: Nexus# sh int...

I am trying to upgrade my ACE Modules from A2(1.3) to A2(3.2) . Unfortunately, the cookie parsing breaks when there are illegal characters and causes a connection reset (RST) when there is an invalid cookie, but only on code later than A2(1.3).The co...

We are having problems when we configure https probe on port 8080, Probe comes up when we configure http probe but not the https one: Can some one confirm is this IOS Version affected by this bug? https://bst.cloudapps.cisco.com/bugsearch/bug/CSCug88...

Hi, I am planning to install a Hyper-V version of WAAS central manager and I have downloaded the file from Cisco site. There are 2 questions I would like to seek for advice. Currently we are running the WAAS CM on VMWare platform. 1. The file I've do...

Hi all, I'm hoping some you may be able to shine some light on a problem we are currently experiencing. We have Cisco WAAS devices at each of our sites and they have been working fine for some time. Since the start of the year we've been receiving a ...

Hi Team,I'm preparing for the EOS of the OE574.If a wave-574 dies after EOS, is there a way to transfer it's license to another wave-574 (replacement)? Is the license transfer required at all to get the replacement working? I couldn't find any docume...

What is the exact meaning of the statement? Do i need to have WAAS server to be physically direct connect to the WCCP Router? or is it possible to put Switch in between of the WAAS and the router (WCCP Router - L2 Switch - WAAS Server)? 

Hello: Right now I am deploying a couple of Nexus 9k, and when I try to enable the fex feature, the system displays the following notice: "FEX config is not supported on Tahoe"   Does anyone has seen this notice before? I am aware that Tahoe is the n...