Application Networking

Hi all,In an evaluation i started using WAAS Express in our WAAS environment.Currently i'm using three routers with WAAS_Express. Due some reason i have problems to register one of the devices.The device registration were sucessfullFeb  3 13:47:39: %...

I'm trying to do souce NAT (NAT client) using an IP address from server side but it isn't working. I think I can use the same multi-match policy to do both NAT and SLB but I'm not sure..Please see attached config.Thanks

Hi all.I have a ACE that shows different outputs in 'sh conn' and 'sh serverfarm':ACE-ASERCO/DATACENTER# ACE-ASERCO/DATACENTER# ACE-ASERCO/DATACENTER# ACE-ASERCO/DATACENTER# sho serverfarm STREAMSERVE serverfarm     : STREAMSERVE, type: HOST total rs...

I have plenty of certs running on my ACE, but when trying to import some Verisign certs, I get the following message:Failed to Deploy config to device: Configure device error: com.cisc.nm.lib.cmdsvc.ssh2.ssh2Exception. Please enable ssh for ACE by ty...

I have situation as where ACE is doing load balancing on 2 real servers for application traffic.The requirement is that I want to use the same VIP & real server ( with same IP addresses )  for SFTP traffic.But in this case I want to send traffic only...

Hi everyone,Please see below for customer requirement and please advise on which of the products will be appropriate. Specification:·         Estimated 300 concurrent application users·         2 application servers seating behind the load balancer, ...

Using the CSS11501S-K9 load balancer, when the LB directs the call to the appropriate client, we would like the request headers to reflect the clients IP instead of the IP of the load balancer.  Is there a way to configure this so that the LB replace...

Hello,password recovery procedure is during booting ACE device (both - module or 4710). I'm interested about password recovery for devices configured in redundancy.- I have two devices, configs are sync- I will restart one of them (it doesn't matter ...

We are implementing backup exec between two of our datacentres (simple inline setup between the two datacentres)   The traffic is by default being classified as  ** map default ** and is having full LZ/DRE/TFO applied.  We do not want DRE applied.  T...

I just received a brand new WAVE-574 for our branch office, and noticed that it was shipped with a single drive configuration.  I just bought an additional hard drive from Cisco to go into this WAVE-574 so the disks are configured in a RAID 1 for red...

Is there a way to build an ACL or a security feature that I can turn off that will allow servers that are loadbalanced by the ACE to traceroute through the ACE to networks outside the ACE module?

Hello,I've setup a loadbalance policy where the ACE looks at a tcp/443 VIP and then balances sessions (based on source IP) to two different webservers. On these webservers the SSL cert is offered to the client and then we're all happy and secure.Howe...

I have setup simple load balancing for our SharePoint service using a two content rules. The port 80 is intended to just redirect to port 443. The rule goes to services pointing to an ASP that should redirect the http to https. The port 443 rule goes...