Application Networking

Hi ,I have configured multiple context in ace . ( Eg : context 1 VIP is 10.10.10.5 and context 2 vip is 20.20.20.5 ) I need to connect two AVS-3120 ( failover). In this scenario how can i connect AVS in ACE ?Thanks in Advance .-- Aslam

Hi All,If all the real servers in the serverfarm fail the health probe, how is CSM going to response. 1) Will the vserver status be as "not in service" and will the VIP still be pingable?2) Will the CSM response immediately to the client with a TCP r...

Hello.I am designing a CSS11506 solution in one-armed mode for an allready existing network (I am balancing webservers).In my topology I have to use Client Nat in order for things to work.However I've been told that the servers need to see the client...

How can I achieve active/active configuration with csm in a 6500? Can I do it with 2 csm in the same chassis or I need two chassis, each with one csm?

Hi Sir,I'm configuring fault tolerance between two ACE modules installed on two different Catalyst 6513 switches. I have one Admin context and 3 user contexts.Do I need to configure 4 "ft group", i.e. one context per group? E.g. config:ft group 1 pee...

Hello,I need a little help here.We have installed the Cisco Works on Windows server 2003 32 bit, and right after Cisco wirks are installed CPU and MEM usage grows very fast, and at the end when mem is full server freezes and it stops responding at al...

HelloI am wondering which interface does the SSLM module use to retrive the CRLs - administrative or production ?Thank you in advanceRegards Lukas

HiI have failed over the GSSMs using the "gss primary-to-standby" (on the primary)command, followed by "gss standby-to-primary" (on the standby).The failover worked successfully, with the execption of the following error message on the interim standb...

WAE installed between two sites for NAS filer replication has failed during numerious attempts to kick off NetApp SnapMirror Replication. When we turn off TCP optimization, compression and application services the replication continues. Cisco CCIE lo...

Hello,I noticed in CSS11500 documentation Cisco advice not using level 2 devices for Inter-Switch Communication (see at link at the end). After sniffing, it appears ISC works with broadcasted ethernet frames. So how should we proceed to link two redu...

We have a particular VIP functioning for a Cognos product that the users are stating they are losing communication with the vip at random times during peak usage. We have been unable to find anything in the DoS statistics, ethernet stats, logs or ser...

Hi All,I have two portals which are located behind the load balancer (client side), the configuration is basic.I have faced a problem on accessing these protal via SSL port (HTTPS) using the virtual Ip address which represents them, knowing that the ...

Attach is the Visio as well as config for the India site. The Visio has 2 tabs (POC-WAAS and Proposed-WAAS). The POC (Proof of Concept) tab does not have the spare 3660 installed yet but I plan to do that soon. The "Proposed WAAS" is where we would w...