Application Networking

Hi,Is it possible to do bundling of the ethernet interfaces on the CSS... I mean something similar to etherchannel...Any inputs.. ??Regards

Hi,My network topology is as per the nwtopo.jpg file. Now in this if I want to do load balance for the server farm-2. How would my physcial and logical connectivity look like and how would my routing will happen..Note:For some security reasons I cann...

Hi,I want to know the function of Session Accelerator module in the CSS, how does it helps in preformance improvement..I searched for some documents about SAM in cisco website and could not get any...Can anyone share some docs or urls abt it??Regards

Hi,Could someone tell me what the default ttl value for rst packets originating from a CSS, Im assuming its 128 as see from packet captures of health checks. Thanks in advance

Hi All,In the network layout below, does the ACE need to be setup in a routed mode to work? can it be also be setup in a bridged mode in this scenario?Network Cloud <--> Firewall <--> ACE <--> Router <--> Server Farm.Any refences would also be greatl...

This is my Load Balancer CSS11503 configuration!*************************** GLOBAL *************************** no restrict web-mgmt cdp run ip route 0.0.0.0 0.0.0.0 10.138.78.34 1 ip route 10.0.0.0 255.0.0.0 10.138.78.33 1!************************* I...

Hi,I have two CSS that I use to load balance RDP connections to two WTS servers. I dont have switch behind CSS so they are connected back-to-back via cable. All server facing ports (including back-to-back ports) are in the same VLAN.CSS1 is primary f...

Hi,I have a requirement to do SSL transparent proxy for multiple websites sharing the same VIP. I want to use the host header information from the client to decide which certificate to use.I can't seem to find anything in the documentation on how to ...

Hi Sir,I'm configuring WAE-7326 & WAE-612. There are two Gigabit Ethernet interfaces: Gig 1/0 and Gig 2/0.What is the other interface typically used for? For e.g. my primary interface is Gig 1/0. What should I use Gig 2/0 for? I wish to use it to bac...

How exactly this command benefits permanent flows?

Is there a way to NAT a server initiated connection based upon destination similar to what's possible using a souce group in a CSS. What I'd like to do is NAT a server initiated connection to the Virtual IP when the server is connecting to the intern...

We have few servers whose default gateway is the load the balancer. Even though no services/VIP's configured for these servers they cross the Load balancer to access other networks..it was working fine until recently wherein these connections got dro...