Application Networking

Request asked by customer. Thought I would run this by the forum first. Can you please raise a ticket with Cisco TAC asking why Excel files in 97-2003 file format cannot be fully optimized when compared to the same file being saved in the latest file...

Over 150+ WAAS in production.  CM upgraded from 4.4.5c to 5.3.1.  Then all devices upgraded to 5.3.1.  Optimization Policies are defined in the group setting AllWAASGroup.  After all the devices were upgraded, the CM fails to retain the device group ...

We have NEXUS 7K configured with VPC's to all  our uplinks.we would to run PIM BIDIR but the documenations sayd BIDIR is not supported with VPC's The switch takes all the commands and it looks like we all the correct (*G) states for bidir Does anyone...

Hi,I have several questions for replacement of ACE30 module at C6513. Please help me because it is urgent situation. I should replace an ACE30 module by this week.There are questions below.[Situations]Several days ago, the ACE module which was runnin...

 I configured ACE30-MOD-K9 in bridge mode and I configured a server farm with his real servers. The traffic passes and is balanced correctly between all RSERVER. But I can not contact a server that is on the same vlan of the serverpharm but doesn't b...

Hi. Having 2 x ACE 4710 I HA pair. The primary ACE stops tp forwards traffic, but it responds on icmp, the gui logon page is also reacheble, but it is not able to log in to it. The primary is tunrned off, so the secondary can take over. Since the it ...

Hi. Having 2 x ACE 4710 I HA pair. The primary ACE stops tp forwards traffic, but it responds on icmp, the gui logon page is also reacheble, but it is not able to log in to it. The primary is tunrned off, so the secondary can take over. Since the it ...

Any ideas how i can use the most optimum way to block external IP address to be able to access a page on our VIP External IP Address : Non-RFC 1518 IP addressesInternal: 10.0.0.0/8 (the following page should be available to an internal network URI to...

HTTP Traffic to a specific host is causing a issue for my WAAS devices. This request goes my proxy so I cannot block by IP address. I believe there is a hidden command that will take a host name to keep WAAS from attempting to optimize traffic from a...

Hi. I'm working on the Cisco ACE 4710 to be able to load balance web Traffic between several web servers. but despite following the steps mentioned on the Cisco configuration guide (specially this link and related docs: http://docwiki.cisco.com/wiki/...

Hi,I have to enable a layer 2 connectivity between my two data centers. There is one pair of Nexus 5000 switches in each data center. Can I form a double sided VPC (also called back to back VPC) between these data centers using 5Ks only? Thanks.