Application Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

All,Please forgive my asking this question again. I was injured shortly after asking the last time and out of work for a long period of time.My problem stems from needing to allow my web servers to initiate traffic to the outside world from behind ou...

a.edens by Community Member
  • 1103 Views
  • 5 replies
  • 0 Helpful votes

All,Can anyone advise on the best way to re-direct entire domains to a new domain?Specifically, our problem is that our original domains are all being retired. As of a certain date, I would like to re-direct every request of *.olddomain.com to a "sor...

a.edens by Community Member
  • 736 Views
  • 2 replies
  • 0 Helpful votes

We have several 11501. Some of them have a module CSS501-SSL-INT listed when a show module is issued. Others don't have this module listed and a search on CCO for "CSS501-SSL-INT" came up blank. Is this module required to terminate SSL on a 501? Can ...

dagates by Level 2
  • 567 Views
  • 2 replies
  • 0 Helpful votes

We setup our pair of CSS11506 units in VRRP redundancy mode about 2.5 years ago. All of services are created individually, one on port 80 and one on port 443. Each of their VIPs are the same, port 80 and 443. It was a requirement for our 443 applicat...

cbuzzard by Level 2
  • 541 Views
  • 3 replies
  • 0 Helpful votes

I have a customer with CSS 11503's and 11501's running 7.30 (not sure which build).When using the 'show summary' to read the number of service hits and comparing that with the Total Connections count of 'show service', the Total Connections end up sh...

grwilli by Frequent Visitor
  • 1195 Views
  • 5 replies
  • 0 Helpful votes

HiIn the CSS Global load balancing I was going through the description of using the setup desribed, but I am confused about the following statements"An application session is configured between two CSS switches in two different geographic locations. ...

aiyappa by Level 2
  • 454 Views
  • 1 replies
  • 0 Helpful votes

HiWhat is the difference between content routing and content switching. Are they required to be integrated together or are they seperate solutions. With content routing we use the DFP,BCP, WCCP and other protocols to receive information. Are these pr...

aiyappa by Level 2
  • 736 Views
  • 4 replies
  • 0 Helpful votes

I have a simple question. Can someone tell me how to access the management port on the css 11150? I configured the ip and mask on the management port and condigured my laptop for a ip on the same network. But i am unable to connect.

kope by Level 3
  • 445 Views
  • 1 replies
  • 0 Helpful votes

I have a customer that wishes to move their CDN to a new subnet. It is a simple CDN (1 CDM and 2 CEs). I had read a while back that changing IP addresses on devices already registered in a CDN must follow a certain set of steps. Can any one point me ...

rraze by Community Member
  • 822 Views
  • 2 replies
  • 0 Helpful votes