Application Networking

Currently CSS 11500 is setup on inside network behind firewall and is set with a default route of our core switch. If possible though would like to load balance servers on both the inside and DMZ networks. Is this going to be possible and if so how...

Hi,In a corporate data center, I would like to have some figure on the current amount of traffic flowing through the CSS. Having studied technical information regarding fastpath FCBs, slowpath and Flow Manager FCBs I try to interpret the values given...

Hi,our customer has the problem with the quotation marks in the variable in the script for CSS. When the release value contains the quotation marks the problem arise. How can he write the quotation marks in the script? Have you got any idea? Thanks f...

Hi, I have just a little experience with a CSS 11501, so this may be a dumb question.I created a service and content rule for a FTP server behind the CSS.This works fine, the public address is translated to the private address etc.But what i really w...

I have TAC case opened about this CSS problem. The TAC engineer said everything looks okay but doesn't know why it wouldn't work. I just found out he is going to be away until November. Before I requeue the case, I thought I would try to see anyone h...

The attached config is referring a server-to-server load balance same vlan.The config is based on:- csm routed mode- server source address "natted" as soon as initiate session- server source session pointing a Vserver to balanced again on the same se...

Hello,With a username (level user) and restrictions with dir-access & restrict commands on a CSS, the command "sh run" is always authorized.Is there anybody that knows how to prohibit this command ?Thanks for your help.

I have created a userlevel enable 5 which allow users to set real servers inservice or no inservice.When I start Ciscoviwew device manager for CSM and login with userlevel enable 5, I get as last conversation a promt for enable 15 password. Is it pos...

1. what is the default value of the keepalive timeout. (after which time the service goes dying, if the keepalive packet is not responded)2. Can I change the keepalive timeout by configuration ?thanks in advancesascha

Hi Is there anyway to hide the HTTP header information? If my web server is accessed from the internet, you can see the web server version.Can the CE or CSS rewrite the header with dummy information?

We are balancing 5 microsoft proxy servers. The keepalive we are using is a TCP 8080. We have seen occasions where the proxy will respond to an 8080 syn packet but the proxy service is down. Is there a better keepalive to use for load balancing a ms ...

I have 2 CSS11501s that I want to load balance 2 web servers with. If I run VRRP on the VLAN interfaces of the CSSs so only one responds can I still connect each web server to a separate CSS and still do load balancing between the web servers? I know...

My customer encountered a problem recently. It's that they can't login Yahoo mail when using CE510 as proxy server and return error 999. But it's ok for hotmail and other secure sites. If not using proxy it works. They have been using this setup for ...