Application Networking

Hi all, working with ECDN (CE,CDM) running ACNS4.0.1 and trying various configurations for the live streaming, i have the following questions: 1] I have enabled the WMT Server on the two CEs with a license key. I would like to do the same on my CDM, ...

I have got two CCS 111520. One is working, the other is spare, which I want to make it work as warm backup or load balance to the other. Could you please tell me how? Thanks.

CSS11000 was upgraded with new IOS image.However, it did not take the current config (which was 'wr m') when rebooted from the new image. It seemed to have taken the config from another disk partition -?!. We had to revert back to the old boot imag...

Recently installed Cisco CE-505 and the customer wants to direct everything to Microsoft Proxy Server for authentication and URL filtering with SurfControl. I added the command: http proxy outgoing host 192.168.90.2 80 primary - which directs all H...

we are planning to start DSL and we are the largest ISP in pakistan,, we will be the first here,,so kindly guide me

I have a customer who wants to know if load balancing 2 Checkpoint firewalls can be acheived by using local directors.Would this require a local director inside and outside of both firewalls?How would a conversation that passes through a local direct...

I am trying to set up FTP thru a localdirector and cannot get it to work. If I target the real address, I connect fine. If I target the virtual address, no go. I've tried SERVICE FTP-PROXY to no avail. FTP config is:real 165.215.41.43:21:0:tcp isv...

My webservers hosts multiple sites and naturally I use host header names because I only have ONE ip number. Each website have its webdata located on a NetApp filer on the network. When one website is disabled the corresponding service is still marked...

Is there a way to configure more then one heartbeat link between 2 redundant CSS's ?Regards

Audio (streeming) file download hangs at about 7-8 M completed during the download through CSS11000. Content rules: content xxxxxxxxxxxxxxxxxxxxxxxxx add service xxxxxxxxxxxxxxxxxxxxxxxxxx add service xxxxxxxxxxxxxxxxxxxxxxxxxxxxx protocol ...

CSS 11150 (5.033)When using this configuration combined with two webservers IIS 5 and host header names the CSS markes each service as Down. When disabling host header names the services is marked Alive again, but then the idea with multiple sites on...

I would like to have my server (behind CSS) initiate connections to a database server with its private address. (database server is on my internal network, css is on my DMZ) I would also like the server to initiate connections to the Internet with t...

I've two webservers, A and B, sharing the same webdata on a NetApp filer. A CSS 11150 (5.033) have a content rule, C, with a VIP registred in internet DNS.I've added A and B to C. When using default "Keep alive type (ICMP)" on services the site is fu...

I'd like to write a web page to read the service summary. I'm using Content Switch SW Version 5.00. It looks like the xml interace can write but not read. Is there any method to read the CSS service status from an active server page?

Diagram: cisco2501A--CSS11150--Catalyst4006--Cisco2501BSyptoms:When I was trying to download image form Cisco2501B to Cisco2501B, a message displayed:Accessing file 'c2500-i-l.112-9' on 100.l1.1.1...Loading c2500-i-l.112-9 ... [timed out] [failed]The...