Our Guest users are able to connect on WIFI. I was able to verify it successfully authenticated on our CISCO ISE and WLC is working properly. Is there a way that I can Reset the policy counters on CISCO ISE via CLI? Please let me know
I have a problem on the Switch C2960 that I have legacy even after updating IOS Version 15.0(2)SE11,show vstack config it is compatible with Capability: Director | Client and Oper Mode: Disabled, so it is disabled for Smart Install and Cisco bug ID C...
The message in the title does not disappear (appears only in the PCisco Bug Discussions, Cisco Bugsublisher) after upgrading my entire cluster.Only until I ran a post upgrade check on the Publisher and then a reboot made that disappear.Why do these m...
When logged into the C2960XR-48FDP-I through the Web GUI, "Cisco {{platform}} {{deviceDescription}} {{version}}" is observed in the top left corner where the actual device platform and version are expected.The same happens with the save, update, user...
copy running-config startup-config [########################################] 100%Configuration update aborted: request was aborted.reload!!!WARNING! there is unsaved configuration!!!This command will reboot the system. (y/n)? [n]Other chats say that...
I am working on N9K-C93240YC-FX2. But I am not able to save the configuration in switch. Please find the below result.
[########################################] 100%Configuration update aborted: request was aborted
Even I cannot upgrade the NX-...
In CCMP UI when PQ is accessed we get a error that the "Required Relationships are missing. These may still be importing - please try again later".
We have some PQs that are being affected by this problem. Even waiting for the 30 minute CCMP cycle, t...
I'm managing the firewall using Firewall Management Center (FMC). How can I disable the process using FMC? I cannot enter anything at the CLI other than show commands.
I encountered this bug on firepower 1140 in ASA mode, OS version 9.16.4.62. But for me workaround didn't work. Only way to successfully show access-lists was through more system:/running_config command.
Be aware, because I tried to fix this bug with ...
Hi,
Recently some ACI Leaf-Switches did a reset reason: reset-triggered-due-to-ha-policy-of-reset
Service: fabrictrack hap resetVersion: 14.2(2f)Hardware: N9K-C9348GC-FXP
I cant understand why this is happening
I have a C930048P-E and it boots into a switch: prompt. I cannot force it into ROMMON nor can I tftp the following IOS file to the switch. switch: setBOARDID=20564IP_ADDRESS=192.168.0.1MAC_ADDR=84:8A:8D:E0:5C:80MODEL_NUM=C9300-48PMOTHERBOARD_SERIAL_N...
