How can I configure device-tracking attach-policy IPDT_POLICY on the all ports?Or it isn't work with netflow config?
Forum Posts
Helloi have a question, is it best practice for both fusion router and Border node in stacks ? because in document how to configure fusion router for the border and fusion are different logic thank you
Hello Cisco community, I have a question regarding the DNA Center which is the following : If a switch is managed by DNAC through NETCONF, when I change the switche's configuration manually through CLI (for erxample adding a VLAN), can I use the "res...
Good morning all,Can you use DNAC to archive your network devices configurations? Hope you all are staying safe.
Hi Gents, Can I start the cisco SDA setup with a single DNAC DN2-HW-APL node for production and add the remaining 2xDN2-HW-APL server after the installation is complete, maybe after a few months ? and is there any limitation (some functions need a f...
Resolved! DNA confusion
Hello GuysI really confused with SDA / SDN / DNA.... Please make it clear Thank you
Resolved! DNAC onboarding and day N configuration
Hi I have a customer that wishes to use DNAC to deploy new switches to lots of remote sites to replace their EOL switches. We cant use normal PnP due to the WAN being MPLS and with the routers being under service provider control and not forwarding t...
Hi,I have configured compliance policy which controls "authentication open" under access mode interface. In violation message i can gather interface id by typing <1.1> (first output of first regular expression). Now i also want to gather interface de...
Hello Cisco, Does anyone know the ETA the DNAC on-prem Virtual Appliance release? https://blogs.cisco.com/networking/deployment-options-expand-with-new-cisco-dna-center-virtual-appliance-2 Thanks
We set up a single DNAC using only the enterprise port and cimc.When it comes to NFS Backup, traffic has to traverse a firewall if it leaves the enterprise port.Which port does NFS take by default and is there a way to use another port than enterpris...
Hi friends,I'm trying to upgrade 3 access switches catalyst 9300 through the DNA CENTER. I'm trying to download a new version through the IMAGE REPOSITORY, but I get an error "ERROR NCSW 90008 unable to reach cisco.com du to an internal error" i ch...
How can Cisco DNA and Cisco Prime Infrastructure provide integrity to prevent any one change running configuration on whole infrastructure devices?How can Cisco DNA and Cisco Prime Infrastructure rewrite the last backup configuration back to network ...
Hi there, I was trying to configure the DNA Center from the KVM console. I followed the installation/configuration guide, but when validating the last steps the progress bar froze in "update_node: waiting for kong service to be running.." and then s...
Hello community, can someone explain to me how incremental backups work? The Administration Guide says that the backup is kept for 14 days. How can I understand this? At the beginning a full backup is created, then incremented for 14 days and after 1...
I have some different switches in DNA with problem "High input/output discard on Switch interfaces" for examplecisco c2960+24PC-L - with Physical Access Control System devices and ip cams, there is not much traffic, about 45mbit output and 1.5mbit in...
