Cisco Catalyst Center

Hi,So first this is NOT a question about integrating ISE and DNAC / CatC. It is about after that.The most confusing thing I have found is understanding what CatC will setup for you on ISE and what you need to configure on ISE yourself. I have not bee...

I want to onboard an ISR4321 as ERspan destination in DNA, i am not able to find any suitable documentation, but i got a confirmation from cisco that onboarding of this device is possible. CatalystCenter Version is 2.3.7.6-70319 When i start the rout...

i decided to walk through subject workflow on 2.3.7.6 Cisco DNA Center User Guide, Release 2.3.7.0 and 2.3.7.3 - Configure Traffic-Copy Policies [Cisco Catalyst Center] - Cisco1) despite of i have no compatible HW in the DNAC to configure Traffic Cop...

bt mistake i upload wrong file here and i can't remove it , how can i remove it?

I need to purchase cisco license for model c9200l-48p-4g because it fails to route VLAN until I have license so how to purchase that license and how to install that license?

I am writing maintenance procedures for SDA fabric edge nodes. We are looking for more guidance on using maintenance mode.We have fabric APs connected to the fabric edge. Does each AP need to be placed in maintenance mode if we intend to reload the f...

Hi everyone,We are initializing dnac and want to change the managementment ip set before, when we access KVM to enter maglev winzard it does not show up and keeps flapping with error "ERROR: Post_Install is in process, cannot run winzard. Exiting..."...

Hello there!I'm interested in MultiChassis Etherchannel and MSTP in the same L2 domain.Question 1: MultiChassis Etherchannel (MEC) for Catalyst 9k is supported only with StackWise virtual, is it correct?Question 2: Is it mandatory to enable StackWise...

Hi,I am planning to use 9006 ASR @ core location and 9300 as a Distribution Switch and planning to run multiple services from distribution switches using MPLS (In both core and distribution). So kindly suggest me it will work or not and which model a...

Getting this error when trying to upgrade to version 17.09.05.SPA.bin, the device has enough space so I dont think that would be the issue. mage Activation3 minutes 32 secondsTask NameImage ActivationTask StatusFailure (NCSW40000: Error occured while...

LanAutomation実施後はENデバイスは自動でライセンス登録が実施されCSCM上で管理デバイスとして見えてくる想定でしたが、現状見えていません。こちらについて、LanAutomationだけでは自動でライセンス登録が実施されCSCM上で管理デバイスとして見えて来ないのでしょうか。見えない場合、DNACからプロビジョニング等により、自動で登録する方法をご教授いただけないでしょうか。なお、現環境でのインターネット通信はDNACをプロキシーサーバとせずに直接インターネットアクセスする構成です。

We have a Cisco 3850 running the ipbasek9 technology package on an expired smart license. We have other 3850s running the ipservicesk9 package, also with expired smart licenses. Is it possible to run "license boot level ipservicesk9", reload the firs...