Please check the SNTC service contract.Please check SNTC contract of SN FDO25430V56.I can verify this SN is belonged to PO and SO number as below.* PO number: STR2021-418* SO number: 113181489
Forum Posts
Would it be possible for a IE-4000 switch to get a screen shot showing the Adaptive Mode filter setting when configured for GrandMaster-Boundary mode. One of our OEM's wants to standardize on using this setting on a CIP motion application. Ken
Hi team, I'm having a strange problem with 4 Macbook Pro's at work. All of them do not find the room system. So far I have done following troubleshooting. Checked Microphone if its workingChecked if Mic was used by another problemUninstall/Reinstal...
On the web GUI for a SG-500 52 switch, I am missing the option to change the Display Mode between Basic or Advanced. How can I get this option to appear?
Hello, Can you please help me with the SIP firmware for 7975G. 7975 SIP IP Phone Firmware Files Only - Compatible CUCM Versions: 7.1 Your help is highly appreciated. Thank you
Hello,I have two 2504 wireless LAN controller that are plugged into the LAN. One as primary and the other as backup.When I disconnect the primary, the backup must take control of the WIFI access points but no one devices can connect to them.I waited ...
Hi,I'm not even sure if what I want to do is possible, I've got a sneaky suspicion it's not, so I thought I'd ask the people that would probably know before I waste too much time searching the Internet only to be let down in the end I work for a lar...
We are told, "Meraki is not able to run GLBP." We currently have MX67 firewalls, and noticed that when just the primary firewall has a failure on WAN1 that it doesn’t fail over to the spare MX in the HA cluster with WAN 1 connected. If we could run G...
I'm trying to upload a license file for my CSR1000v. we don't have tftp or ftp servers. TAC was doing a copy paste the license file through a putty session. please let me know what are the commands for that ? do we need to change the lic format ?
HiWe have 2 x Cisco prime appliances that I need to upgrade from 3.4 to 3.9.I have already upgraded our primary appliance from 3.4 to 3.7. The next step is to install 3.9 on our secondary appliance and then restore a backup from 3.7 build to 3.9 as r...
I ran into this bug and its now affecting my production environment. Any ideas how i can get around this ? https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvs72378 any help is appreciated
Can you upgrade an Expressway from 12.5. to 14.0 or do you have to upgrade to 12.7 prior to 14.0?
Resolved! Packet Tracer question - cable modem?
I am newbie to using Packet Tracer. I'm running one of the labs in the Introductory course and it requires using a cable modem. I am running 7.2.2 which is clearly newer than the version of PT used in the tutorial. I have searched the entire menu an...
Resolved! Catalyst 2960-Plus series
Good day,I have a confusing situation, I'm trying to set the golden images on the company switches and I'm busy now with the 2960-plus series. The conflict is coming out when I compare the golden image from cisco site which is c2960-lanbasek9-mz.152-...
Hello community,is there a way to terminate a Putty SSH session that outputs to the console with a sh tech-sup output loop. The device is a Nexus 7 kbest regards
