Hello,I am not aware of what I am being asked for in preferences. I am not an IT expert. I would like an explanation of the terms used in the setup phase of the account. where can I find that glossary? For example, what is the "Video System Address"?...
Why cisco the router displays the message"would you like continue for initial configuration?" yes/no ,. And if everyone says no, why cisco router still has this first question with the option yes/no. If the router is not going to configure properly t...
I am not sure if this is the "location" to place this, the direction to get here was not very intuitive compared to other forums. Anyway, I received a used Cisco 3560G 48-port POE switch. I plugged it in and waited for all lights to light up. I then ...
Hi all,
how to read the level of a ciaco 891at the Wanport.SFP out ???
router#sh int gigabitEthernet 8GigabitEthernet8 is up, line protocol is up Hardware is PQ3_TSEC, address is XXX) MTU 1500 bytes, BW 1024 Kbit/sec, DLY 10 usec, reliability ...
Let me first share my background. I have a B.S. of sociology and want to change careers to IT. I don't really have a technical background, but I do have basic computer knowledge and experience. After much research, I want to get my CCNA cert and ulti...
Hi Guys, I know this question has been answered so many times, but I looking for advise on my case specifically.I have recently completed by CCNA R&S and exploring my way forward. I have 8 years of experience in Telecommunication industry where I hav...
Hello,
I am trying to load IOS XRv on my EVE-NG lab but the boot wouldn't execute, as a resoult I receive the logs below:
Unable to access "/dev/ser1" (2)
Restricted Rights Legend
Use, duplication, or disclosure by the Governmen...
I use AIR-AP 1572 EAC, but I can not install IOS file.
It seems that ethernet link does not work.
I got a console connection, and I got the 「ap:」prompt on the terminal.
The state of the LED,
Yellow Yellow Red Red(flashing)
This is caused ...
Hi, I just want to check what is the default incoming and outgoing call history can be saved in CDR records and can we make it as unlimited. Please advise.
Thanks & Regards,
Syed