N2K-C2232PP not detecting GLC-TE

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-15-2018 03:07 AM
Hi all,
I have two N5K and 2 no of N2K, FEX and VPC configured.
Whenever i connect GLC-TE or any SFP (MM or SM) its not detecting but if i reload the N2K (like power off and ON back) then its detecting. What is the reason and how to fix it.
Thanks
- Labels:
-
Data Center Networking
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-15-2018 07:22 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-15-2018 08:36 AM
Hi
thanks for your reply.
the port is in shutdown state while configuring port speed , port config(access/trunk). Then i insert the GLC-TE and issue no shut command but still N2K not detecting the GLC-TE (including SFP 1 gig, 10gig, mm , sm in any combination) without reloading the N2K
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-15-2018 08:59 AM
You can look into the following defect (workaround listed)
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvf79399/?rfs=iqvred
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-16-2018 01:47 PM
sounds like some sort of bug, they should be recognized immediately.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-16-2018 07:48 PM
let me raise a TAC with Cisco. Later i will update you what is the RC
