Solved: Re: CIPC / CCME Question

cjhunt · ‎01-22-2007

Hi,

Does anyone specifically know whether there is a firmware parameter required for CIPC ("load" command) when running it with CCME?

I have doen a fair bit of digging and all I can see so far is that you can specify the phone type as "type cipc".

I understand that CIPC is basicaly an emulation of 7970, so isn't the 7970 load appropriate?

Thanks,

Chris

Rob Huffman · ‎01-22-2007

Hi Chris,

I have not setup CIPC with CME but according to the attached doc no firmware is required. Have a look;

Cisco IP Communicator 2.0

**No firmware required**

Cisco IP Communicator 2.0 is supported by Cisco CallManager Express 3.3 using Cisco IOS Software Release 12.4.

From this doc;

Cisco IP Communicator Overview (CME)

From this doc;

Use the normal phone provisioning commands. In the "type" command, use the "CIPC" keyword to identify this phone as a Cisco IP Communicator.

Hope this helps!

Rob