H323 Bind issues

[Kaushik Ray]

(config-subif)#h323-gateway voip bind srcaddr xxx.xxx.xxx.xxx

Bind IP Address configured. Please remove before reconfiguring

I am getting this message despite no bind address configured. anyone seen this issues before?

RTR#sh run   | include bind
RTR#

Any advise will be much appreciated.

[Chintan Gajjar]

yes, if you alredy did bind this interface with src adress previously.

please use

no h323-gateway voip bind src

and then try to issue the command

also you can see thebinding in sh run and will show where interface is alredy bind.

regards

Chintan

[Kaushik Ray]

that is the issue, i cannot see any bind existing on the router

[Aman Soi]

Hi Ray,

can u cross-check in show startup config?

regds,

aman

[Kaushik Ray]

RTR#sh startup-config | include bind
RTR#

no :(

[islam.kamal]

Hi

try the below

RTR#sh startup-config | include h323-gateway

[Kaushik Ray]

RTR#sh startup-config | include h323-gateway
RTR#

[Ayodeji Okanlawon]

Give the router a reload and that should solve this for you.

[mechris123]

hi,

the command will be invisible after you have changed the interface ip address.

you just issue a " no h323-gateway voip bind srcaddr " on the interface then should you should be able to execute the new binding with no problem. no need reboot.

[Aman Soi]

if you have access to router on console, try doing default interace 

[Kaushik Ray]

only have remote access :(

[islam.kamal]

Hello

1- if you did not find a solution , but be patient many suggestions from expert people will come . You can follow the following Mr/Aman solution , or do a backup for the configuration and then do # write erase and add your configuration again , but of them it should be using Console .

thanks

please rate al useful information

[islam.kamal]

Hello

Can you check all the configurstion , after display sh run?. There is a bind command already existing , check under loopback, voice vlan. interfaces . Share your "sh run".

Thanks

please rate all useful infromation

[Kaushik Ray]

!
version 15.0
service timestamps debug datetime msec localtime show-timezone
service timestamps log datetime localtime show-timezone
service password-encryption
service compress-config
!
hostname RTR
!
boot-start-marker
boot system flash:c2900-universalk9-mz.SPA.150-1.M4.bin
boot-end-marker
!
card type e1 0 1
logging buffered 4096
!
aaa new-model
!

!
!
!
!
!
aaa session-id common
network-clock-participate wic 1
!
no ipv6 cef
no ip source-route
ip cef
!
!
ip vrf 3RD_PARTY
 rd
 route-target export
 route-target import
!
ip vrf DATA
 rd
 route-target export
 route-target import
!
ip vrf forwarding
!
no ip dhcp use vrf connected
no ip dhcp conflict logging
ip dhcp excluded-address 172.27.165.1 172.27.165.25
ip dhcp excluded-address 172.27.165.129
!
ip dhcp pool VLAN1
   network 172.27.165.0 255.255.255.192
   dns-server xxx.xxx.xxx.xxx
   default-router 172.27.165.1
   option 150 ip XXX.XXX.XXX
   lease 3
!
ip dhcp pool VLAN133
   network 172.27.165.128 255.255.255.192
   default-router 172.27.165.129
   lease 0 3
!
!
no ip domain lookup
multilink bundle-name authenticated
!
!
!
!
isdn switch-type primary-net5
!
crypto pki token default removal timeout 0
!
!
voice-card 0
!
!
voice rtp send-recv
!
voice service voip
 fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback none
 modem passthrough nse codec g711ulaw
!
voice class codec 1
 codec preference 1 g729r8
 codec preference 2 g711ulaw
!
voice class h323 1
  h225 timeout tcp establish 3
  call start fast
!
!
!
voice translation-rule 100
 rule 1 /^.*/ /xxxxxxxxx/
!
!
voice translation-profile MAPOUTSIDE
 translate calling 100
!
!

hw-module pvdm 0/0
!
!
!
!
redundancy
!
!
controller E1 0/1/0
 line-termination 75-ohm
 pri-group timeslots 1-31
 description ### PABX ###
!
controller E1 0/1/1
!

!
!
!
interface GigabitEthernet0/0
 description ### Trunk  ###
 no ip address
 duplex auto
 speed auto
!
interface GigabitEthernet0/0.1
 description ### Managment, Server and Voice network ###
 encapsulation dot1Q 1 native
 ip address 192.168.1.1 255.255.255.0 secondary
 ip address 172.27.165.1 255.255.255.192
 no ip redirects
!
interface GigabitEthernet0/0.2
 description ### Lan ###
 encapsulation dot1Q 800
 ip vrf forwarding DATA
 no ip redirects
 ip tcp adjust-mss 1400
 bridge-group 2
 bridge-group 2 input-address-list 702
!
interface GigabitEthernet0/0.5
 description ### Riverbed AUX Port ###
 encapsulation dot1Q 5
 no ip redirects
 ip nat outside
 ip virtual-reassembly
!
interface GigabitEthernet0/0.133
 description ### Internet Wifi ###
 encapsulation dot1Q 133
 ip vrf forwarding 3RD_PARTY
 no ip redirects
 ip accounting output-packets
 bridge-group 33
 bridge-group 33 input-address-list 733
 bridge-group 33 output-address-list 733
!
interface GigabitEthernet0/1
 no ip address
 duplex auto
 speed auto
!
interface GigabitEthernet0/2
 no ip address
 duplex auto
 speed auto
!
interface GigabitEthernet0/2.950
  bandwidth 1024
 encapsulation dot1Q 950
 ip address 172.27.165.254 255.255.255.252
 ip flow ingress
 ip flow egress
!
interface GigabitEthernet0/2.951
  bandwidth 768
 encapsulation dot1Q 951
 ip vrf forwarding DATA
 ip address 172.27.165.250 255.255.255.252
 ip flow ingress
 ip flow egress
 rate-limit output 768000 8000 8000 conform-action transmit exceed-action drop
!
interface GigabitEthernet0/2.952
 bandwidth 256
 encapsulation dot1Q 952
 ip vrf forwarding 3RD_PARTY
 ip address 172.27.165.246 255.255.255.252
 ip flow ingress
 ip flow egress
 rate-limit output 256000 8000 8000 conform-action transmit exceed-action drop
!
interface GigabitEthernet0/2.959
 encapsulation dot1Q 959 native
 ip address 172.27.165.242 255.255.255.252
 ip flow ingress
 ip flow egress
!
interface Serial0/0/0
 bandwidth 1024
 no ip address
 encapsulation frame-relay
 load-interval 30
 no keepalive
 priority-group 1
 ignore dcd
 no clock rate 2000000
!
interface Serial0/0/1
 no ip address
 shutdown
 clock rate 2000000
!
interface Serial0/1/0:15
 no ip address
 encapsulation hdlc
 isdn switch-type primary-net5
 isdn timer T310 120000
 isdn protocol-emulate network
 isdn incoming-voice voice
 no cdp enable
!
interface BVI2
 ip vrf forwarding DATA
 ip address 192.168.1.1 255.255.255.0 secondary
 ip address 172.16.199.1 255.255.255.0
 no ip redirects
 ip accounting output-packets
 ip nbar protocol-discovery
 ip tcp adjust-mss 1400
 !
interface BVI33
 ip vrf forwarding 3RD_PARTY
 ip address 172.27.165.129 255.255.255.192
 ip accounting output-packets
!
ip forward-protocol nd
!
no ip http server
no ip http secure-server
ip flow-top-talkers
 top 20
 sort-by bytes
 cache-timeout 30000
!
ip nat inside source list 150 interface GigabitEthernet0/0.5 overload
ip route 0.0.0.0 0.0.0.0 172.27.165.253 name default
ip route vrf 3RD_PARTY 0.0.0.0 0.0.0.0 172.27.165.245 name Default
ip route vrf DATA 0.0.0.0 0.0.0.0 172.27.165.249 name Default

control-plane
!
bridge 2 protocol ieee
bridge 2 route ip
bridge 33 protocol ieee
bridge 33 route ip
no call rsvp-sync
!
voice-port 0/1/0:15
!
voice-port 0/2/0
!
voice-port 0/2/1
!
voice-port 0/2/2
!
voice-port 0/2/3
!
!
!
!
dial-peer voice 100 pots
 description ### PABX ###
 destination-pattern XXXXXXXX
 port 0/1/0:15
 forward-digits all
!
dial-peer voice 2000 voip
 preference 2
 destination-pattern .T
 progress_ind setup enable 3
 session target ipv4:xxx.xxx.xxx.xxx
 voice-class codec 1
 voice-class h323 1
 dtmf-relay h245-alphanumeric
 playout-delay nominal 130
 playout-delay mode fixed
 fax-relay ecm disable
 fax rate 9600
 fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback none
 clid network-number XXXXXXXX
 no vad
!
dial-peer voice 2001 voip
 preference 1
 destination-pattern .T
 progress_ind setup enable 3
 session target ipv4:xxx.xxx.xxx.xxx
 voice-class codec 1
 voice-class h323 1
 dtmf-relay h245-alphanumeric
 playout-delay nominal 130
 playout-delay mode fixed
 fax-relay ecm disable
 fax rate 9600
 fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback none
 clid network-number XXXXXXXX
 no vad
!
!

[Chintan Gajjar]

can you try negate command and then try to issue command once agian.

also on your router, if you issue below commanad whta output it gives?

sh run |  s bind

ther will be binding defined somewhere

regards

Chintan