I want to manage ME1200 via ME3600X-24FS-M, IOS 15.3 However, there is no command "platform nid-controller" on ME3600X... I have tried to upgrade ME3600X IOS to 15.4,15.5 and still no luck.. What's wrong with it? Did I miss something?
So, the general idea of the config is as it follows - the peering for this setup is done from one AS to two other ASes (that are also connected via another provider, so the two other ASes belong to the same entity, while they connect to my AS). The t...
What version of IOS or IOS XE is required to support UTI G.8032 on the 7600 Platforms? Currently have RSP720-3CXL-10GE with 7600-MSFC4 C7600 MSFC4 Daughterboard Rev. 2.1 and 7600-PFC3CXL-10GE Policy Feature Card 3 Rev. 1.1 Please advise with any cave...
Hi all, I'm trying to configure a interface with two dot1q tags but I can't do it.I think thats is because my line card doesn't support it but I can't find any doc to confirm it. I have a 7606-S chassis with two WS-SUP32-GE-3B, one WS-X6548-RJ-45 and...
if there are two equal cost ISIS routes, then there will be two LSP's for a FEC. but in MPLS only one FEC should be used.on what basis will this selection be made?can we balance load across links in a port channel in MPLS, how?also in VPLS scenario w...
Hi Sirs:Please answer each question separately:1) What are the main differences between EoMPLS and VPLS?2) What Cisco devices support EoMPLS? Only edge devices? Why?3) What Cisco devices support VPLS? Only core devices? Why?4) Using only EoMPLS, ho...
Hello.. We have 2 C898EA-K9 routers and we want to connect them through G.SHDSL back-to-back, but under the ATM0 interface we cannot configure the interface to work as CO.. Is the CO mode supported on this router? do I have to purchases a license to ...
First of all, I'm from Argentina, sorry for my not enough english, could be not 100% clear.this log is appearing on this switch all the time. Someone can tell me what's happening? %C4K_RKNOVA-4-INVALIDTOKENEXPIRED: STANDBY:(Suppressed 201 times)Expi...
Hi,
Im trying to understand the correct behaviour for the UNI port and l2 tunelling on the ME3400E switch running as a layer2 device. No layer3/mpls on it.
In the setup like below, ME3400E#1 UNI facing port G0/4 has 'dot1q and l2-protocol tunnel'...
How do you implement a peak shaping QoS policy on the Cisco ME 3600X. My aim to shape a service instance but to allow the shaper to burst over the shape value to a specified amount, if there is available bandwidth on the physical interface, queing an...
We have been looking for a better solution in supporting "bonded DSL / bonded EFM" Currently we are using CEF with good success however we are beginning to see draw backs to it when it comes to VoIP and packets arriving out of order. Historically we ...
hi in my network, I have a switch (D) connected to multiple switches(A1,A2,...) and the VLAN's repeat in each of these switches (A1,A2,..). I want to use MPLS layer2 VPN concept here. please tell me should I go with VLL or VPLS and why?also if possib...
