Metro

We have started to install ME2600X as access switch for FTTHTrunk ports are configured with rep and service instancesThese interfaces are facing Cat 4500X switches with rep edge ports. Northbound is a 6880X VSS and this is connected to the legacy net...

HelloI have one Adtran Router on platform: NetVanta 4660 EoX L2/L3 Router having OS version R10.11.0.E. I want to replace this router with Cisco ASR 1002 router. There is EVC configured on Adtran router having the following configuration:interface gi...

I have to configure L2TPv3 tunnel between two ends on 2921 routers. Can anybody tell me while configuring xconnect interface the following config will work or not?R1pseudowire-class testencapsulation l2tpv3ip local interface f0/0!!interface f0/0ip ad...

ME3600X (153-3.S4) -Tried configuring ERSPAN on ME3600 switch using new code but it did not work. Configuration guide does not mention anything about the ERSPAN. However, commands are available on the platform.Would like to know if ERSPAN feature is ...

I have created L2TPv3 tunnel between two routers. Now i don't know that the tunnel is up or down. I have run the command but it is giving the following output:R2#show l2tp tunnel%No active L2TP tunnelsCan anyone tell me how can we check L2TPv3 tunnel...

Can anyone tell me is there any method to configure q-in-q tunneling on 2921 and 2911 routers without using Switching Modules?Does IEEE 802.1Q-in-Q VLAN Tag Termination support 2921 and 2911 routers? Regards,Mukesh KumarNetwork EngineerSpooster IT Se...

Good morning community,I'm after some clarification on the VPLS functionality available on the 6500 SUP2T supervisor. I have been doing some research as I’m looking at hardware to build a 3 site MPLS/VPLS carrier network for a client and was original...

I am trying to do etherchannel between two ports of ME3600 and two ports of Cisco Switch 3400 with either Pagp or LACP. If the ports are with a simple configuration (trunk ports) the etherchannel is up and running properly. But when i apply a simple ...

How to provision Cable modem ??

Hi, I am currently trying to configure my ASR 901 router with 15.4(3) OS version to use  the PPPoE over one of the Gigabithernet port, but I'm facing some issues because in every tutorial I have seen, they specify to perform the "pppoe enable global"...

Hi,I have a question regarding the following policer and shaper on the me3600 platform service instance:interface GigabitEthernet0/1 switchport trunk allowed vlan none switchport mode trunk mtu 9000 service instance 1 ethernet  encapsulation default ...

Hi, I've a ring topology where run REP with Cisco ME-34xx and works fine. However I deployment others 'non-REP' switches in this ring. After do it, a fail betwen non-REP switches, dosen't change the REP topology and keeps the Aternated port in Block ...

I want to connect a L2 domain redundantly to A VPLS cloud. I am struggling to get this done without creating any loops.The customer has a its own L2 domain and wants to connect it via L2 to the VPLS cloud. As the customer has also spanned vlans betwe...