Metro

Hello everyone! I'll appreciate it if anyone can help me! I have a router ASR 1002 and I need to configure a PPPoE server in this ASR, but when I configured the machine I realized that the PPPoE server was apparently normal. The client is connected, ...

Hi, Guys, I'm a beginer with NSO, and now i want to re-deploy a service to fix the broken configs, but i can't remove any other out-of-band configs that have been made to the device, what command or step i should do to implement this? Any help will b...

Hi, Guys, For Cisco NSO, i'm going to undeploy a service instances, dose it remove the service configuration from the both network and NSO??? Thanks!

Greetings,I am trying to establish CFM connectivity using emulation (CSR1000v).I am running VPLS (Manual discovery) for end to end connectivity.The topology in use is CE4 - PE2 - PE3 - CE6Connectivity in place , what am not able to get the remote mai...

Now that Cisco has acquired Accedian network I can seem to find a manual for a AMN-1000-TE device.  Anyone know where to find one of these?

Hello,I'm facing this issue with a connection between two NCS2k-400G-XP-LC cards.Site A has Remote fault on port 8-1 and Site B has SIGLOSS on port 8-1. Both ports have QSFP-100G-SR4-S plug-in to them. I tried to replace the MPO cables, the cards the...

Hey, I'm running Flexible Cross-connect service over EVPN and i'm trying to establish CFM CCM over it. I'm running it in a lab, and i'm getting "configuration errors present" in the "show ethernet cfm services" but i can't tell where is the error.My ...

Hello, I'm using an ASR9K and i've configured a bridge domain attached to an EVI that is connected to another device.The configuration of the L2VPN Bridge Group is as follows. RP/0/RSP0/CPU0:cisco-asr9k(config)#do show run l2vpn bridge group Mark_Kaz...

Hello,Looking for some help on this trunk config I maybe don't understand the service instance configuration on a Ncs 520 but I'm unable to see the other N520 connected to this device with these configs plugged into each other. Please let me know wha...

Good day!I have 2 Catalyst 3650 in stack (role intervlan routing)#show versionCisco IOS Software, IOS-XE Software, Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 03.06.06E And 2 ISPs provide service VLAN to remote office - VLAN ID the...

sir  cisco SG350-28 28 -port management switch S.NO: DNI230303TU THIS SWITCH WARRANTY PERIOD ?HOW TO RMA CREATE ?PLS SEND DETAILS 

Pim{ rp{ static{ address 10.126.1.1{group - ranges{239.0.0.0/24}}}}{Int Fe -0/0/0.0 mode sparse;Version2;}Try to migrate Juniper configuration to Cisco ASR but configuration not working properly