MPLS

Hi,I want to measure the real performance measure for R4 voice, signaling, sigtran traffic in my network. What would be the ideal parameters reflecting the real traffic, keeping view the CPU load on 2811 SLA routers.I am using currently 1500 byes per...

Is it possible to make a VRF as a NetFlow and SNMP traps source on 12.2SR IOS release?

Hi,I m trying to create a psuedowire between 6509 and 3845 which are connected by means of IPV4 network. 6509 is running with code as 12.33SXI and i found that the encapsulation method under pseudowire class is only mpls not the l2tp.. If i configure...

Hi everybody!I would like to ask about what reasons do rsvp nodes have to not exchange rsvp packets?Every ivolved switch in mpls domain runs rsvp to extend MPLS network to TE (Traffic Engineering), but none of them sends rsvp packets.If the routing p...

We currently connect our remote sites over an ISP's hosted MPLS network. Occasionally we run into a website not working and all signs point to the MPLS network. I've seen this problem before with IPSEC VPN tunnels but not across the MPLS connections....

I have a 6500 facing my core network and tried to enable L2TPv3 (xconnect) on a vlan SVI but the vc will not come up. the module i am using is WS-X6748GE-TX card. Do i need a SIP module for this to work?

Hi all,I am getting this error message in RP router.027609: Oct 14 09:05:14.432 GMT: %PIM-6-INVALID_RP_JOIN: VRF cctv: Received (*, 225.86.67.83) Join from 172.30.0.176 for invalid RP 10.160.255.3Basicaly my multicast IP range is 239.160 not the 225....

Hi,Can some one explain the best practices for security measurements for an MPLS network? Requirement is of device hardening, EDN/DCN/Internet integration,and multisite placement of services to be secured...

We are opening up a second data center at my organization. The location is about 60 miles from our primary data center.At our primary data center we use an MPLS network for our WAN. We have ll remote locations on our WAN and we have a DS-3 that con...

Hi Topology:A--DS/PE---CORE/P---ISP/PE--P---ISP/PE--BAS per above topology,am not able to transfer files with MTU frame size above 1492 though the MTU configured on interface is 1500.The link between DS/PE---CR/PE is mpls enabled i have configured th...

Hi All,Just wondering if a CE router is configured to receive an IP address from a P router acting as a DHCP server, what configuration is required on the P router for DHCP pool?At the moment, I have configured the devices for DHCP as follows-CE1--PE...