MPLS

Hi,I have a few questions:1. If you have TE tunnel with FRR configured for it, what will trigger the switchover to backup tunnel?In my mind: a. Link Protocol down on the interface b. RSVP signalling Now two other problematic ones are: c. IGP neighbor...

Hi,I would like to know which IOS support "address-family VPNv6"? I have 7204VXR & 7603 with sup2 card. Thanks

Hi , How will I calculate the MPLS mtu , to allow 5 labels.1) 1518 + 5 * 4 bytes or2) 1518 + (20 bits * 5 ) + 12 bits .If the answer is (1) ,please explain theneed of the same..?Thanks in advanceThomas.

hi i have a ccna and ccnp but these days where ever i go for interview i have been asked abt traffic shaping and MPLS.....plz can someone help me out....can some one plz recommand any good book so that i can learn this technology as well.....thanks i...

dear sir, we have the hp pda 6365 and wish to use this pda connect with gprs/edge/3g and hopefully can access the local mpls network and surf internet. Any idea how to perform this? please share. thank you very much. hereby is the link to the pda.h...

hi guys,This is the problem : I need to receive from a GigaEth both some multicast streams and a unicast control traffic to be filtered. So, on a 3750 there is a trunk vs data provider, and Interface Vlan X for mcast and Vlan Y for outside unicast in...

Hi,I'm trying to apply "GOLD" QOS to vrf traffic that is terminated on eth subints, but class-map is not allowing me to match on subinterfaces:class-map match-any GOLD match mpls experimental topmost 5 match ip precedence 5 match input-interface fa...

Hi everybody,I've seen guys saying that ICMP has low priority on MPLS Domain and normaly i can lost some packet when I ping some router on mpls domain, but I'd like to know when it is true, because I did mpls course and I didnt see nothing about that...

hi,I would be greatful if you could send me a good document on designing Route Reflectors for MPLS VPNv4 with best practices.Rgds,Harin

Hi,I want to set up a very basic lab for MPLS VPN. Which low end routers can be used for PE and P. I hv less budget.Thx,G

Hi , I tried to configure MPLS over a TE tunnel by following this link : http://www.cisco.com/en/US/tech/tk436/tk428/technologies_tech_note09186a0080125b01.shtml#case1 .The problem happened in this tunnel interface config : ----!interface Tunnel0ip...

I have 2 routers conected with ethernet by an transport equipment because the routers are in diferent countries, but I have many loss of packets, MTU is configured in 1520. any idea???