Network Access Control

I am trying to move to closed mode with ISE 2.1. The switches are running XE 3.6.4. Only the RADIUS probe is enabled in ISE because I am using device sensors on the switch. The issue I'm running into is that Avaya IP phones that use LLDP are not bein...

I can see the source:unknown recorded in for any authentication logs and i expect it to be source:IP address of the actual source. It is working fine on other switch versions, can any one of you confirm if this is expected and how to fix it?

Hi community, I'm into this issue where I configured ISE 2.0.1 no patch with anyconnect nam eap fast and nac agent. Not using ac posture because of licensing. So, everything works ok, client provisioning and agent does pop up correctly and it takes a...

I have one Cisco ISE license for primary and secondary ISE device, and these two are in HA mode. both ware deployed in a VM. My question is, I'd like to place one cisco ISE in headquarter(primary one) and place the another cisco ISE in another buildi...

Hi all, I am trying to migrate Cisco ACS 4.2 to ACS 5.8 and i have few problems with importing all of the users from the old ACS to the new one. Let's say that every user is a phone number and in the old ACS every user has its own ip address, when i ...

Hello all, I am trying to import a list of network devices with the minimum required information but it is failing. I get the following error "Failed bad input. Please remove markup scripts." If I add the devices manually it works fine. I am runnin...

Hello All, AnyConnect Base Client: 4.2.03013 Network Access Manager Module 4.2.03013 ISE Compliance Module 4.2.03013 Cisco ISE Server: 2.0.0.306 On some of our client deployments (*all Windows 7 PCs) we have noticed that the ISE Posture modules co...

Hello, just a short question. We have 2 WLCs in China and the ISE Server is in Germany. There is between 200ms and 300ms latency between the Server and the WLCs. We use CWA guest portal redirection. We are having troubles with the users in China, t...