Network Access Control

I need to upgrade our existing ACS from 5.1 to 5.3. We have two ACS servers but one failed and was rebuilt by a 3rd party supplier but upgraded it to 5.3 hence the requirement for the upgradeFrom reading it seems you carry out the upgrade via the  re...

Hello,  I have just install ACS 5.4 on VMware,  during the installation I created a username (admin) with a password,    now after installation is finished,  I can use that  Username & Pass  in the CLI of my ACS config,     but when I access and open...

Hi, experts,I'm trying to import network devices on ISE 1.2.0.899so I downloaded the template and opened with notepad and wrote all the nessesarry information.and I tried to upload to ISE, and it just said import failed. no reason..does anyone know h...

Hi Team, i have created the Root certificate and Server certificate in .cer and .pvk format with Makecert tool. When i tried to install private certificate on Cisco ACS then it is showing as following error .                                    " Unsu...

Working on a project for a large customer & i need to add close to 3000 Switches in Network devices.  Rather than add each switch, I would prefer to enter a wild card entry of 10.x.x.30 = Switches for example.   When i did an import of 500+ switches,...

Hi,One of our remote offices is having real issues with Wireless connectivity.The errors we have been receiving are as follows:Event5440 Endpoint abandoned EAP session and started newFailure Reason5440 Endpoint abandoned EAP session and started newRe...

Hello everyone! I urgently need your help please. I would like to configure the ports of a switch for 802.1x. when I type the command: Dot1x harbor auto-control on the interface, the protocol is down and users are disconnected wiring. Can someone hel...

We're currently running a Cisco ACS 5.3.0.40 VM appliance and using this to authenticate wireless clients from a Cisco 5508 WLAN setup.  I've setup a Service Selection rule to match RADIUS Protocol and a Compound Condition where RADIUS-IETF is lookin...

Dear All,Quick question, is Cisco MCS 7825 Unified Communication Manager and Cisco VG224 Voice gateway support TACACS+ protocol for device management purpose?Can please let know which version are supporting on it? These devices will under control usi...