Network Access Control

Hi, I have an ACS Server 5.1 which is used to authenticate my cisco and non-cisco devices. however when I take report on my authentications, the time shown in the report is wrong. However, when I take my mouse pointer to the report , the correct time...

Hello,I have a new for use ACS 1120 with 5.0.0.21 software. The purpose of the ACS is to authenticate Wireless users based on an ACS defined external identity source, LDAP. The following configs are made:- LDAP is configured as an external identity s...

Hello,How is it possible managed a server radius failure when I'm using low impact mode and a port acl is applied ?Is there a similar configuration like critical vlan used in high security mode ?Regards,IarnoSent from Cisco Technical Support iPad App

Hi, We are planning to implement 801.x with dynamic VLAN assignment such that different group will have different access policies to our internal network, however I have a basic question regarding this approach. Say users in sales group is not allowe...

Dears,         i have CAM (primary) in HA cluster , this CAM is replaced through RMA.i need to know the steps required to replace it (license , configuration ,....)Thanks

ISE v1.1.0.665, 3395 h/w.Single Admin/Monitor/Policy node.WS-C3560-48TS      12.2(55)SE5           C3560-IPBASEK9-MFor Client Provisioning I created an authorisation policy as follows:download acl "ACL-POSTURE-REMEDIATION"apply url redirect "ACL-POST...

Ok so here is my dilema, Avaya Phone with Docking station plugged in to it, dot1q passes the workstation fine, but hangs the phone. With out creating a voice vlan is there any way I can have the phone authenticat with mab, and the workstation with do...

Hi AllTrying to work out how to get these access policies on ACS 5.3 to work one after the other and other issues with access policies.1, If i go to Access policies/Access services/Service selection rulesThen the rules seem to be hit from the top dow...

If you have TACACS or Radius by default to telnet to a router or SSH to an ASA  is there a way to put a local username and use both TACACS and local at the same time?  I have only been able to use local authentication as a way of failover when Radius...

Hello,until now we have an ACS 4.1 System up and running and we have several administrator accounts which can only edit users for one specified group. Now we would like to upgrade to 5.1 and I could not find the possibility to give an administrative ...

Hello all-Having an issue with the ASA devices. Here is the relevant part of the configuration:<aaa commands>aaa-server TACACS+ protocol tacacs+aaa-server TACACS+ (outside) host <host ip>key <key>aaa-server TACACS+ (outside) host <host2 ip>key <key>a...