Network Access Control

Hi,We've currently got an ACS 4.2 appliance for wireless authentication and to increase redundancy I want to go for an additional ACS and it makes sense to go for 5.1 as it doesn't need agents and has better reporting.Users are authenticated against ...

I've looked everywhere for some documentation on how to do this.  Does anyone have a step by step on how to configure this?  I'm an ACS newbe, so please try and keep it simple.

Does this product support SNMP V2 & V3 if so how is this setup?

Hi, I have a site where everybody on the inside interface has to be authenticated by a RADIUS Server.  I have that part working but the problem is I've got a lot of AAA entries for exclude.  What I want to accomplish (if possible) is to use access-li...

Hi,I am running ACS 5.1 and having some internal users created under Users and Identity Stores.I can specify the user and password (which works fine), but I can also specify an enable password.This enable password does not work as to enter privilege ...

I have 2 applainces, and I have upgraded both to 4.2.1.15 patch 2. However, the Appliance Managment Software is still at 4.2.0.124. Does this also require an upgrade in order for the appliance to function correctly? What does this management software...

I am trying to remove a device that was added. I know I have to do this via RBDMS synchonization since the device name is over 32 characters long. I cannot seem to find my example or the action codes to delete this device. If the device name is devic...

Hello!Is there a doc or such that points to a configuration for having VPN users coming into the ASA with authentication against AD in addition to a SecurID for two-factor auth?so for example, when a user VPNs in, they are prompted for AD credentials...

I'm having an issue getting to enable mode using Cisco Secure ACS 4.2 for authentication using RADIUS (not TACACS+).  I've added a user to ACS who is able to log into the switch just fine and I added the $enab15$ user to get to enable mode.  The ques...

Hello All,Is it possible to do device administration using RADIUS under ACS 5.1?Regards.

Hi,Since some time we are struggling to get database replication working.On the primary server it is reporting the following on "Database Replication active.csv""07/21/201014:22:58SZ0910WARNINGACS 'SZ0920' not replied to replication request - possibl...

When i connect by console to the l2 switch i can ping all other switches, but from the pc i can not.From the l3 switches i can not ping the L2 switches.Please excuse for creating many threads.Thanks.