Network Access Control

Hi,We have deployed ACS 1113 with 4.1 version recently in our network.I had configured downloadable access list in ACS for remote VPN users.But when user connects to and authenticate to ACS then the user is not able to browse internet from his PC.Ear...

We run Cisco ACS v3.3 (Windows) on two servers over our WAN, and replcate the internal databases for redundancy. The problem is that replications fail between the ACS servers and it is because of the default port the ACS servers use to replicate over...

I'm currently using and older ACS and TACACS+ with a PIX 506E for VPN and have to test RSA SecurID which uses RADIUS IAS. I would like to use both at the same time; the ACS for current VPN and the IAS just to test a single RSA device, but don't know ...

Hi All,Does any one know how can I modify the Login Page appearence of ACS 4.1. I want to add my company logo along with Cisco on login screen. Thanks

I am getting this message on the ACS 4.1 server failed authentications log.The strange point is that i get thme only for a specific timeframe and then they stop.I am using PEAP-GTC as the authentication method with 1242ABG APs and Intermec CK31 clien...

HiI need an ACS box to return IETF RADIUS attributes 135 & 136 to a NAS for the assignment of DNS servers to clients.The ACS 3.3 user guide lists these as supported IETF RADIUS Attributes however they don't seem to be available under Interface Config...

Hi all,Two factor authnetication is considered be any two of the following.1) Something you know2) Something you have3) Something you areI want to know whether any of you would consider the following as two factor authentication...A preconfigured cop...

Hi everyone,I would like to know which SNMP MIB is effective to the operation monitor for Cisco Secure ACS SE. And which SNMP MIB I should monitor by SNMP such as CPU utilization, memory utilization and so on, on Cisco Secure ACS SE. However I can no...

Dear Sir,I have isntalled cacti (latest version) and it is working fine. When i add AS5300 in devices, It was also fine for graph showing about CPU usage, I want to show in graph that how many users are connected, average users and maximum users on A...

Hi Everyone,I have the below working config for TACACS+ authentication and accounting for IOS based devices. Would anybody be able to give me a CATOS version for the config?Many thanks,Danaaa new-modelaaa authentication login default group tacacs+ lo...

Hi,Mistake occurred while configuring 1811 in the remote branch. I' was not in time to add line ?username ?. privilege 15 secret ...? to Cisco config.I?ve executed ?wr mem? and connection was dropped.I?ve configured only enable secret 5 ... andip rad...

We have established a site-to-site VPN tunnel, but we are struggling with RADIUS setup. Problem is that two sides of tunnel use different vendor products. Our service provider uses Juniper's Steel Belted RADIUS, while we use Cisco ACS RADIUS. I assum...