Network Access Control

First time when I boot the ACS 1113 and access through serial port , whenever i put login promp Administratornot getting any password promt for last 40 mnt only cusor blinking.Try to recover through CD that also not performing for last two hrs.Kindly...

Hi, We were configuring the AAA to use one of the TACACS server for authentication,authorization and accounting purpose. When we did the same, the command executed response become slow and even some times gives a message authorization failed. We thou...

Hi Guys,its like I want to have only single user ID (Could be AD account or ACS local account) & want this user account should have level 1 access on some switches,routers & have rights to run specific commands on Core devices,firewall & should have ...

Hi,I'm trying to configure kerberos authentication for local users on Cisco. KDC is running under Windows 2003, but I got folowing error from debugging:AAA/BIND(000002D4): Bind i/fAAA/AUTHEN/LOGIN (000002D4): Pick method list 'default'Kerberos: All d...

Hi,i am just wondering that a network device is sending his requests to the acs appliance with another ip than the configured ip that is configured with the "ip tacacs source-interface" command.The problem occured first when i was searching a network...

Hi,I have a problem with ACS 3.2 and its CSAuth eating memory. There was a bug in the previous versions with the memory leak and according to the release notes the 3.2(1.20) should be free from it but seems like it is still there: in 12 hours of bein...

Hi List, we've adquired a new ACS v4.1 Solution Engine, before we used UCP, with ACS 3.2 Windows based. Can I enable UCP over ACS Solution Engine? is it possible? or maybe I have to use a diferent server...Thanks...!Omar

Hi,I have a strange issue, after few days my ACS freeze completely, including console port. There is a red light and no other indication of the trouble. Does anyone observed the same issue ?

Thank you!

Hello,I have three locations with 3 remote access servers, users are being authenticated against TCACS on ACS 3.3.There is an option to have local IP pools on RAS servers with different IP scopes and same name and have ACS assign this pool name to ea...

Hi,I have several doubts with my 2821 and easy vpn server.-Configuring users, is better using an external aaa server or using the router one?-If I use the router as aaa server, which would be the level of the users configured? level 1?Best regards

Hi, I am using ACS SE 4.0 and I have problem on scheduled acs backups.I am trying to schedule an appliance backup in every 15 minutes interval. I already setup my ftp server (using 3CDaemon) with a user that has full read-write-access to ftp server.P...

Hi,we are using Cisco ACS on our Cisco Aironet 1200 series AP's for Mac-Authentication, using Cisco Aironet on the definitions.But since we would like to have all our switches logins via TACACS+ we have done the following config:aaa authentication lo...