Network Access Control

Can I use Command Auth Sets in CiscoSecure to provide a subset of configuration commands? I want to give Interface commands, but not anything else.

I'm seeing posts that hit all around my questions, and based on my intereptation of the documentation it appears that there is no "shell exec" authorization available to the PIX when configured to use a TACACS+ server for authentication. Is this true...

I am not able to logon to en mode on a router whcih is getting authenticated through an AAA mechanism.

Hello,I'm trying to create a special group of Clients to authenticate via ACS-Server without a password.Creating a user in ACS without a password leads to the error-message "Cannot set blank password for a user unless they are in a VoIP group".If I t...

Need inputs on to do telnet to the ACS from a L3 6513 switch? Am trying to telnet from 6513 from where the traffic passes through a FWSM before hitting the ACS. Am able to see hitcount on the FWSM too.

Need inputs on to do telnet to the ACS from a L3 6513 switch? Am trying to telnet from 6513 from where the traffic passes through a FWSM before hitting the ACS. Am able to see hitcount on the FWSM too.

I've setup my AAA config as follows "aaa authentication login default group tacacs+ enable". When I test config with SSH (ACS turned off)to the router I cannot login using the enable password. The same does not work when trying to connect with Con0. ...

Am doing a telnet to ACS server from L3 switch on port 2002 but it is not working.Error messages are "remote host not responding" from one host and from another L3 it's "closed by foreign host"

Does UCP support M$oft AD or just the local Cisco Secure Database. I know, kind of a simple question, but I really need to know..

I have 2 ACS Servers running on Windows 2003 SP1 and I need to replicate the users and groups from one to another.I can get the replication working and on the master it shows that replication is sucessful.On the secondary ACS Server I do see all the ...

Good Morning Folks;Below is the output from the show aaa-servers from my asa5540. Notice the status "failed". When the status is thus (on both aaa servers) noone can login the the VPN on the ASA5540. I've checked the duplex / speed etc on the ports f...

I'm deploy a 802.1x NAC solution. Users authenticate ok but the VLAN is not assigned to the port. The RADIUS server send the attributes to the NAD (switch 3560). I see the following lines in the radius debug output:02:49:08: RADIUS: Received from id ...

Hi guys,I am trying to assign a vlan to the fa 0 - 3 interfaces via dot1x. Im already successfully using this feature on a 6500, a few 2970 and a few 2940. But the 871 seems to be a little different. Im running IOS 12.4(11)T on the 871. When a host i...

Need inputs on to do telnet to the ACS from a L3 6513 switch? Am trying to telnet from 6513 from where the traffic passes through a FWSM before hitting the ACS. Am able to see hitcount on the FWSM too.

I have been reviewing the ACS 4.0 documentation and want to know if there are any options available for synchronizing the DB using ODBC on the Solution Engine. Looking for something other than FTP, if available.