Network Management

Can someone tell me how to get the Detailed Device View in LMS 4.0 please?From what I have been able to find out I should be able to go do Monitor> Fault Settings> Setup> Fault Device Details, select a device, click View and then click the device nam...

Hi all,Yesterday I installed my first Cisco prime infrastructure 1.2.I'm a bit confused now, is this the integrated version of LMS and NCS? At first sight, there's not a lot LMS in it.I don't see topology services, netconfig etc.Since the release of ...

HiI configured my switches with line vty password and enable secret and I enabled services password-encryption on my switches. I try to add switches to CNA with enable secret without any username but I couldn't. CNA dosn't accept my enable secret. Wh...

Hello Community,Can someone please tell me if its possible to load a EEM version on a 3600 higher than 2.1 or on a 3700 higher than 2.2?CheersCarlton

I like to monitored the status of both Nexus 3048 cpu and memory usage with my NMS (such as prtg) ,but i found the oid (ftp://ftp.cisco.com/pub/mibs/oid/CISCO-PROCESS-MIB.oid) can't work right. Does anyone can help me ?

Bonjour j'ai installé ciscoworks LMS 2.6 sur mon serveur et en accedant au Device Credentials and admin j'ai ce problemeDCA Server is down or inaccessible aussi j'ai  JRM server is down or inaccessible for this  userI have installed a ciscoworks LMS ...

Hi All,I 'm facing a issue with the discovery module, when i create a job for discovery either immediate or scheduled. The job triggers and status would be running.But i'm not able to see the  progress of the discovery status(it displayed ""No recent...

Good day,I have an issue with our CiscoWorks. After I applied several patches to the CiscoWorks, the apache services wouldn't start. Every time I try to start "CiscoWorks Web Server" service, it gives me "Windows could not start the CiscoWorks Web Se...

Hi,i have a new cisco prime network control system appliance (NCS) I completed the initial installation however post installation it performed a reboot and is now stuck at Init Level 3.I have restarted the machine several time but the same result.

Hi Netpro I ve recognized some strange issue with LMS 4.2 , when the router becomes down or unreachable , the LMS doesn't send any event as Faultview,also when the router comes back online the LMS takes 1 hour to show its state as  reachable , how ca...