Network Management

Does anyone know, or has anyone heard, if Cisco will be replacing a Free Upgrade from LMS Prime 4.1 to 4.2? Or will this be a purchased upgrade?

Hi everybody!I have some questions about monitor of status of services on Network Devices such as HSRP, Etherchannel (between Access ports and Servers), etc. How we can track those informations in addtion to Syslog. Is it possible that the Fault Moni...

Hello,Windows 2003 server R2 with all patches installed. When I try to install LMS 4.0 I the installation stucks with  "Default logrot Changes". Nothing else will happen.Any Ideas?RegardsHubert

I have a problem with 1841 router - It wont't boot up and there is a message Correcting primary nv_flashPlease HELP

I am trying to upgrade my IOS on a 3550 switch.The switch has 15MB of space total.When I delete the current IOS it leaves only 8MB of space.I need 10MB of space for the new image.Where is this other space being taken up?Can I do something to free up ...

Hi All,i am facing this issue while trying to see the configuration of deviceDevice diagnostic tool =>Device troubleshooting => Select device =>Run device troubleshooting details => below error messageSC attached..Thanks in advance..Regards,Channa

Hi Guys,Greetings,I'm trying to configure the Monitoring Thresholds in CiscoWorks LMS 4.0. (Monitor> Fault Settings> Setup> Settings Threshold). to monitor an optical interface of an ME 3400 switch idea is to give the test to the values ​​of (Optical...

I am trying to copy my IOS to my pc using Solarwinds.Solarwinds is Started.I am able to ping from my pc to the fa0/1 port on my switch.These are in the same subnet.-------------------------------------------------------------------------------------P...

Is it possible to easily operate both Prime Fulfillment 6 AND LMS 4 on single Solaris 10 server?

Hello,I'm pretty new to LMS and I have taken over a couple of LMS 3.2.0 standalone servers (two different networks). When I reboot them they tend to be slow coming back up (20-30 min). I"m thinking this may be due to the fact that LMS was reinstalled...

My console shows that I have 51 of the 96 devices are out-of-sync.  I have am running up to date IOS, but it does not seem to be tied to firmware version or to model.  Many have the "VLAN:Running" is shown in the events.  When I run a sync job, it st...

I recently installed and configured the Prime LMS 4.1 Soft Appliance. After discovering the devices on the network I ran a credential verification check on everything. All of my devices passed accept for the Nexus 7010s and Nexus 5020s -- these show ...