I am trying to install Cisco APIC v 5.2(e) o a VMware virtual machine. The installation starts and after a few secons stops and vm turns off.I am using aci-apic-dk9.5.2.2e.iso and have given 4 cpus and 16GB of RAM to the vm. What do you think the pro...
Forum Posts
Hello people, I'm currently planning to upgrade our Cisco Prime from a fresh 3.7 VM to 3.9. Since our current 3.7 is a FRESH installation, according to Cisco documentation I can follow the in-line upgrade procedures. Everything seems clear to me , bu...
Hi everyone As per post title, I am trying to implement internet connection and set up a web server. The diagram I have created works fine in terms of hosts being able to communicate with each other. I have set up the "Perth Router" as the DHCP serve...
Resolved! S0/0/0
Hi I am trying to configure a router as per the attached table. I am struggling to find a router which has int s0/0/0 - I checked all the available routers and various modules that you can install in PK. However, I can't find any which has s0/0/0. So...
Hello,I have a problem with a CBS220 switch that I wanted to register with PNP.The PNP service recognized the equipment and started to provision the image.The problem is that it didn't work until the end, so I wanted to delete this provisioning to st...
I create a playbook to restore my router backup using ansible, but it didn't work properly. I attached a screenshot of my error. ---- hosts: CR01connection: network_cligather_facts: falsetasks:- name: push config fileios_config:src: "home/yugan/deskt...
I'm currently using PI 3.9 Patch 1, to send an interactive command to all my switches (9300 & 3850) but it fails every time. I usually have less issues when I perform "install remove inactive" on all my switches before upgrading them with prime. I wa...
Hello Cisco Community,Our DOAT Team, for security reasons, run periodically assurance tests, using their own script on our Cisco backup files. We run periodically backups, a copy of which passes through the scanner of the DOAT team.Recently we added ...
Hi,I have received some C6880-X Switches that are used. Rather stupidly, the previous owners have left the configurations on them. I have managed to change the config register to get around the enable password but, for some reason, the Configuration ...
Not sure if anyone can help, but I will try my best to explain here:Multicast stream is having an intermittent problem where cc errors are produced on an envivio system so the stream stops then displays a coloured strip on the screen then plays again...
Is there anyway I can get email alerts for BGP events especially when an adjacency goes down? I need help configuring it using either EEM or Cisco Prime.
Resolved! DHCP Failed, APIPA being used.
Hi, i am using an ip address of 10.19.1.0/24 for this network and the switch is connected to the routers and devices at vlan 100,i used 10.19.1.1 on the router gig0/0 and starting ip 10.19.1.2 on the server. when i configure dhcp on the devices, it s...
i open a cisko account. and then i install cisko pocket tracker app. but now i cant use the app. after login i dont get guest mode to using app. please help me
Resolved! Collision domain
Hi everyoneJust a quick question please. Given the attached screenshot, I believe there is 4 broadcast domains and 11 collision domains. It looks like 11 collision domains is not the correct answer. Do we counts the ports on the devices to determine ...
Hey.I was just trying to get an overview of the network before jumping on the activity (Exploring Networking with Cisco Packet Tracer: Set Up Your Small Office Network). And there's no way to see the device type of any device already installed in the...
