Network Management

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi All,I have had used LMS in the past however it was always an installed setup.Now here I'm facing a situation wherein I have to startup a new LMS environment from the scratch.Could you please advise how to start with the setup i.e. after installati...

I have cwlms 3.0 this is configured to integrate with ACS 4.1All of our managed switches and routers are tacacs enabled apart from our ccm servers (ccm3.2)RME is correctly flagging the servers up as NON ACS.CM is discovering the servers but is unable...

Hi,i have installed LMS application onas follows;Server 1:DFM and CM (DCR Server)Server 2:RME (DCR Slave)Server 3:IPM (DCR Slave)Server 4:CV. (DCR Slave)There are the issues:1. There`re more than 3,000 devices in the network,but it can only discover ...

sameoj1881 by Level 1
  • 1548 Views
  • 20 replies
  • 0 Helpful votes

Hi,Just a quick question on device discovery using CDP and SNMP v2.Scenario:Site A consist of the following cisco deviceRouter - 10.10.10.1Sub-interface VLAN 1 - 10.1.1.254Switch 1/Vlan 1: 10.1.1.1Switch 2/Vlan 1: 10.1.1.2Switch 3/Vlan 1: 10.1.1.3INT...

Sometimes, if i add a device to LMS 2.6, it doesnt appear in the DCR straight away, but does show in the "devices not configured in ACS" report. However the devices are in ACS, and after i stop/start dmgtd, the devices appear in the DCR.Obviously i d...

hello.when I tried to debug one of our cisco routers, I got the output below.anyone know hwat it means??seem like an IOS bug..back up doesn't kick in..ThanksMay 7 15:53:33.992 UTC: ASSERTION FAILED: file "/vws/bvb/CPY-v123_8_t_throttle.V123_8_T11/vo...

jsheriony by Level 1
  • 743 Views
  • 2 replies
  • 0 Helpful votes

I am trying to unmanaged a Se0/1 interface on a router in DFM but the drop down option isn't available. It's defaulted to TRUE the other interfaces on the devices have a managed state option true or false available. What should I do to correct this.

dionjiles by Level 1
  • 743 Views
  • 2 replies
  • 0 Helpful votes

Hi,We currently have a single LMS 2.6 server running all applications and integrated with ACS. The deployment guide says multi-server setup is supported in LMS 2.6, but I cannot find a good link that gives more info. Can someone please point me in th...

v_saru by Level 1
  • 1013 Views
  • 6 replies
  • 0 Helpful votes

When I run config collection job I see following errors for so many devices that are actually managed. I try to manually synch arcive and fails again with the same error, I go in and delete the device and add back in the RME and that works. I noticed...

nawas by Level 4
  • 656 Views
  • 1 replies
  • 0 Helpful votes

Hi experts,I have problem with email notification in CiscoWorks LMS 3.0.1.When I need to confirm some action by email, this email is recieved without sender. Item "From" in this email is empty.Have anybody any idea what is the problem?thanks sarka

stesarova by Level 1
  • 698 Views
  • 1 replies
  • 0 Helpful votes