Network Management

I have a LMS 2.6 with all the applications installed. RME is not functioning properly. to explain in detail,In the device Management of RME , I am able to see all the devices, but when I tried to do a inventory collection for the devices, the job is ...

Hi, Merry Christams and Happy New year! Does any one share the steps to Install Ciscoworks LMS 2.6 on Windows server. Thx.

Hi Experts,We require to block all sorts of streaming videos from being viewed from the Internet in our network.Please can someone advise if we need to block any specific port for this or is there any other way of doing it.Thanks in advance.Regards,I...

I have a router that has been configured in TACACS and suddenly started to fail login attempts.TACACS is configured to source from the Loopback Internface on the router and I can ping it from the TACACS server.I can log in with localy configured cred...

Hi,I have a Ciscoworks LMS 2.5 server, most of the RME functions ( syslog collection, configuration management .... ) could not work properly since last month. I attached MDC support information, could you please help to identify the problem?Best Reg...

I was installed IDU 13 on RME 3.5 , but router 2800 series are not supported in performance monitor yet . But in IDU 11 (and later) router 2800 series should be added.May somebody help me kindly ?regrads

Hi,I have installed LMS 2.6 properly.Everything seems fine except, I am not getting the alerts & activities.Pls let me know what I have to do ASAP.Sachi

On a semi regular basis the ATM interface of several models (857/877) goes down while the router doesn't really detect it being down.A shut/no shut on the interface usually resets the condition but I wonder why the router doesn't recover all by itsel...

Hello, I am looking for a software better than visio to design my network and update it everytime, i think MS Visio is not the better one, if it's possible do you know if i can use autodiscovery tool, i would like to use a software which can take cis...

I have a problem with updating 3750 switches using LMS 2.6. I have updated 2950/4506/2811 successfully with the same Netconfig job but the 3750's fail every time. Here is the LMS error: Message: Command(s) failed on the deviceTFTP: Failed on the de...

We have a 2811 providing internet connectivity through a adsl line and I am trying to implement qos in order to improve bandwidth usage and prioritize traffic. I suppose the best place to implement qos would be the wan interface on the output directi...

Hello,I am trying to get snmpv3 work on Cisco router and using snmpget to test. ******* 1st test *******On Cisco Router:R1(config)#snmp-server group dead v3 noauthR1(config)#snmp-server user jerry dead v3On Windows:C:\usr\bin>snmpget.exe -v 3 -u jerr...

How do you run TACACS+ aaa queries on a router with a specific source interface? It seems TACACS+ uses an interface with the shortest route to destanation.

Hi,We have a 3rd party (EMC Smarts)Monitoring & Alarming tool for LAN and WAN network; however they charge us for each interface.For WAN (ATM) link, they count controllers, ATM interface, IMA and even AAL5 interface (which reports them thru SNMP).Can...

I have a few 3560 switches and if I log into them via a console cable and type show arp, I only get the switches IP and one other system that pings everything on the network to verify it is up. All the other ports with systems connected and working ...