Network Management

Hello,it would be kind if somebody could answer my questions below:1. What type of snmp traps will in detail be sent if I configure the commandsnmp-server enable traps chassis ?There are already the envmon and module traps which send information abou...

Hello,When two application: Cisco SDM Express and Cisco SDM are installed on the Router flash, how to explicitly choose one or another from the PC Web Browser ?Example.I have configured Cisco 877 Router to use SDM.When I connect to Router from my Web...

I have been getting partial success warnings on a half dozen or so switches in CiscoWorks LMS RME. If I look at the log I get Polling not supported on VLAN RUNNING config. What exactly does this mean and what can I do to correct it? The full error...

Now I cannot log in the NAM ,how could I reinstall the image?

I have noticed that all my Cisco4500 have stopped logging to syslog server. It worked until couple weeks ago, we did change the management IP on them which I updated it but I still do not see anything in the syslog. I have automated action job set an...

I installed the LSM2.6 on Sunfire V245 Server and also installed the update package of Rtr10000 but I couldn't view my router 10008. The error was "http://192.168.2.5:1741/CVng/uii/blank.htmMessageCan't find applicable device package for 192.168.2.6....

When deploying a baseline template and specifying the paremeters from the UI, I am able to click on "Add instance" to get a second instance of a command set. For example, I have a command set defined to configure the access ports on a 3560 switch. ...

When I run User Tracking in Campus Manager, I am unable track IP addresses in a certain subnet to specific ports.Also, the vlan that the subnet resides on is not in Topology Services (but if you check the VTP domain on the switches the VLAN is there ...

I installed the LMS 2.6 Bundled with Ciscoview 6.1.5 and the device update package Rtr10000.cv50.v10-0.zip but couldn't see the ESR router 10008 with IOS version c10k3-p11-mz.122-31.SB8.bin. The package Rtr10000.cv50.v10-0.zip already installed in th...

My Ciscoworks server install on Solaris 9, and tftp already run, but I cannot using RME to maintain the IOS image. I tried to copy the image by command but the following error appears.R10k8-HBT-BRAS05#copy disk0:c10k3-eboot-mz.122-31.SB5.bin tftp:Add...

hiI am using LMS 2.6 with RME 4.0.5.What solve this problem?

I know that nested groups isn't supported on ACS 4.0, but, is it on ACS 4.1 ???See note in page 77http://www.cisco.com/global/IT/solutions/ent/tecnologie/wireless/pdf/avvid_implementation_guide.pdfRegards,Maximiliano.

Hi,At a customer we experience problems with the Syslog Collector. It warns about dropping messages since queue reached its max. Frankly I dont see how this can be. SyslogCollector - [Thread: SyslogObjectForwarder] INFO , 18 Oct 2007 09:29:13,915, Fc...

After installing LMS 3.0 today I noticed I wasn't able to discover any of my devices. Any thoughts or solutions?