Network Management

My CiscoWorks is the windows version and I have three problems here: 1. all devices runnning IOS 11.x are not discovered completely.2. Newer devices running IOS Version 12.x are discovered but they just appear as a green box with a question mark.3. M...

can any body help me regarding , how to crate jitter,http and latency report.

Hello!We are running Cisco LMS and HP Network Node Manager on two different (isolated) servers, it does not work to forward my TRAPS from DFM to NNM, and also, is there a particular MIB/ MIBS to install on the NNM server to interpret LMS "messages"? ...

I have two identical 4506 switches with regard to IOS 12.2(31)SG, bootstrap 12.2(20r)EW1 and module types in slot 2 of the chassis. While trying to write a scrit to pull the serial and type of each card installed I ran into the following. (GOOD)snmpw...

Is there an OID which return the amount of RAM? I found one CISCOmem5minUsed=1.3.6.1.4.1.9.9.48.1.1.1.5.1 which gives me the amount of used memory pool but its about ROM. Thank you in advance

Hi guys, I have a problem with the BBSM 5.3 Server. The administrator creates access codes by duration but sometimes a few ACs get blocked since their creation then the end user cannot use them eventhough the reporting page shows them intac and activ...

LMS 2.5.1Windows 2000My server admins want me to upgrade from Windows 2000 to Windows 2003.Can I just do a windows upgrade to 2003 on my existing Windows 2000 LMS 2.5.1 system?orCan I take a LMS backup off a Windows 2000 server and restore it on a Wi...

Hi,We have a number of sites using an old combination of a cisco AS2509-RJ router, a dialup modem and a APC 9211.this combination allows us to dialin and access network devices (switches, routers, etc) should we loose our LAN connection or screw up d...

can anyone help me configure an automated daily report of all config changes to any device (LMS 2.5)thanks in advance

please briefly explain what is the latest cisco works package includes.how we get complete information regarding all modules same of cisco works..

hi all,please tell us how to install cisco LMS first time.and what sequence we have to follow to install cisco LMS. I have total 5 cd .so please tell us, in what sequence i have to install. sravan

Is there any advantage to configuring ciscoworks credentials with username/password,etc. versus only using snmp community names? Can Ciscoworks do something by logging on that it cannot do via snmp?

I currently use SNMP to monitor the bandwidth on a 7200 and would like to monitor the CPU utilization as well. Is there a MIB I can use to send this info to the NMS?

I know how much memory my 6509 has: 64MBI know how much memory my 6509 needs: 128MBI need to know if i have the available slots to install 64MB more memory without powering the thing down. I have no backup supervisor engine.How can I find out withou...

If I have a 100Mb full duplex link and it is transmitting at full capacity but receiving a negligible amount of traffic will DFM show this as being 50% utilised or 100%?You can see my quandary, what do I set my threshold to? If I leave it at 40% I co...