Network Management

Does the RTR reaction configuration command "threshold-action consecutive" support ECHO (a.k.a ICMP ping) operation?I know it works on jitter operation, but not sure ifit supports a simle echo (icmp) operation.What I want to achieve is to setup a SAA...

I know the standard for 'normal' will be vary from customer to customer. But is there any general guideline on setting the SNMP thresholds? Such as 'what percentage of CPU/memory utilization should be considered as an alert? and what percentage fo...

Hai all,When i try to upgrade the IOS for 7204 VXR Router it failedrcp and tftp both failed.Even i allowed whole IP for both the router and ciscoworks server.But what goes wrong i was unable to find it out.Please clarify JOB ID - 2...

Our ISP has put a 1711 router in place of MS ISA 2000. We host a website that was available to external (web) users as well as internal (lan) users that was accessed by IP. The new router will not enable internal users to type the IP to access the si...

I am looking for a decent Netflow Collector and Reporter. The reporting should be good and user friendly. And more important is that it should benot be very expensive.( below 200 USD) It should generate reports that can present the bandwidth usage ba...

I need to install RME 4.0. Can you please tell me where can I find eval version? Any help is greatly appreciated.

Folks, I have a cisco 3550 EMI switch sending snmp traps to a snmp monitoring device. I have been told to use MRTG as well to monitor port usage of the ports. MRTG is running on a different server. Is it possible for me to configure SNMP on th...

We are running /installing Cisco works with common services 4.0 we need a version of VMS that will run on Windows serer 2003 to monitor IDS can you help

Hi All,Is there anyone out there who could help me out finding the OID used for the Mem Utilization on 3750 Switch.Kind Regards,Wilson Samuel

Server Config -> Setup -> ANI Server Admin -> Device Synchronization is configured to Synchronize from Essentials only (with everything checked), at 2:17am seven days a week. Status Log is set to Log Details, 1000 Maximum Number of Logged Messages, t...

I have discovered a lot of my devices with Campus Manager. I wanted to import all these devices into RME. I have containeried all the modules (RME, CS, CM) by setting up under "user defined groups" setting up the various regions int he organization a...

Hi,I have installed Ciscoworks and see my devices except two routers that have real public IP address. I have added these two router to the package and can access them via CiscoView but the Campus manager only show the devices that Ihave in the priva...

Can we change the default html page that loaded from the router flash memory when we enable ip authentication proxy???

hiiii everybody....i have some doubts regarding SNMS....i would like to know ur valuable help and suggestions in the following....*we can use SNMS for monitoring LL/ISDN links...ok but can we use it to make a report of the line utiliztion time per d...

hwo do i manage VLANs With SNMS? (Creat VLAN, Associate port with VLAN, associat IP Address with the logical interface VLAN)the unique function that i have found to creat VLAN don't permit to associate port with vlan and to attribute an IP to the int...