Hi We are planning for our first FMC deployment and we have no idea how much time and work does it take, can someone please share their experience?How much time does it take to set up FMC in HA?Also, we have for starters around 50+ ISE3000 devices. W...
Hi. We are planning for our first FND deployment and we hav eno idea how much time and work does it take, can someone please share their experience?We have 300+ IR routers to deploy with private LTE APN. Is possible to do Zero-touch-configuration? I ...
Hi,I have a task to create an applet which will permit certain cli command execution based on time of the day. eg: no "conf-t" during working ours. I did write following applet, which kind of does the thing, but it seems not very optimal for me. So I...
Hi,I was hoping someone would know how Prime communicates with lightweight access points when running configuration tasks, e.g. disabling/enabling the radio at certain times. I can only see radio resets on the AP when checking logs. Is it via SNMP to...
Does anyone know of, or have access to an updated version of the IOS retirement table, the only one I can find looks to be from 2007 - https://www.cisco.com/web/software/SPRIT/swretirement/IOSRetirementTable.html
Hello,
I allow myself to post following research which has given nothing
I encounter a transfer error on two switch models
C2960X-24TS-LL
C2960X-48TS-LL
Fault:
% Error reading tftp: //my-ip/c2960x-universalk9-mz.152-7.E4.bin (Connection timed out)...
Hello Everyone, We are using EEM to create automated backups. The EEM script works great, however, it is not transferring the entire configuration. We are getting approx 60-70KB of a 107 KB Run Config. Here is my EEM Config event manager applet BACKU...
We have Cisco ASAv appliance on Azure with Loadbalancer setup. while setting up IKEv2 IPSec tunnel we saw phase 1 is up and phase 2 is failing over peer ID validation, while debugging we saw that Cisco ASAv is taking private IP as peer IP rather than...
Hello all! I have started learning in preparation for my CCNA exam in the future. I am also looking to upgrade from my ISPs provided gateway. My biggest hurdle with hardware is noise/heat, and knowing what I should get as far as some devices that wou...
hello i have a policy-mapwith to class policy-map CheckBand-BandPerUsr
class BandPerUsr
police cir 10000000000
class class-default
police cir 10000000000 i need to get a (Post Policy Size) by snmpi look and find a right oid but value was wron...
Hi, I have a cameras network connecting with a number of IE-3000 Cisco switches, when one of these switch turns on, the entire cameras network stop working for a few seconds and then return to work.
Dear CISCO Team'I hope you're doing well. I would like to bring into your kind knowledge that I am observing an issue related to Trunking/Native VLAN. I have MikroTik Router attached with CISCO 3750-G Switch and connected switch port with Mikrotik is...
Hi, Just wanted to ask if anyone could help me with building a cisco CCNA lab that I could also use later to learn for the CCNP. I have seen this question asked a few times on the forum but they all look like outdated posts. I have also looked at web...
