Network Management

Hello, I got Cisco Prime up and running like I need it. Did have an interesting thing happen where the resources were lowered a bit and the Compliance Service was no longer appearing. We changed it back but the service never came back we had to rebui...

I just got in a NEXUS 2232TM-E 48p switch. The console port is a HDMI cable and I'm not familiar with using an HDMI to access it (Old school). Can anyone guide me to a place on how to access the console? 

Hi, How to bridge mode G1100 verizon router ? I have ASA 5506 behind the verizon router. everything was working perfect untill the power went off and then when came back lost internet. called verizon they rest the G1100 router told me to turn off the...

Hi,  We bought a used 3925 with SPE200 router from Ebay for lab training.  no smartnet, no support.(our Data Center has full smartnet and support)  on board RTC battery run out and our team (IT geeks) replaced it. My question is how to sync RTC clock...

Dear Tim Cisco I Have a cisco prime with version 3.7.1. I see on alarms and events option there are setting of alert will be sent to email in every 30 minutes (i setting 30 mins) until the cases is solved. So, i want to setting the email notification...

HelloI am new to Cisco , and need to configure SRIOV on a 100G network interface within a Cisco server , running RHEL8.3I am familiar with configuring SRIOV with Mellanox adapters on Linux, however can't find any documentation on configuring SRIOV on...

I use Netmiko to ssh to a cisco router and I was trying to apply the BGP configuration using ssh_conn.send_config_set(). Below is a sample configuration to be applied. Expected behavior:bgp router-id x.x.x.x should be configured under the vrf address...

Hi Guys , How do I know if my switch is LAN base or LAN lite?  Here is the output from a sh ver command: Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.2(2)E3, RELEASE SOFTWARE (fc3) ROM: Bootstrap program is C2960X boot load...

I have such a special question, I own a swicht SRW248G4 so this is the first manage swicht from Linksys together with CISCO. Since I used to use it, I wanted to use it now, however I don't remember the IP anymore, putty and hyperterminal won't start....

DEAR ALL MY ROUTER IS CISCO ISR4331OS : isr4300-universalk9.17.05.01a.SPA.bin I AM USING THE NBAR protocol-pack : pp-adv-isr4000-173.1a-40-57.0.0.pack I LOADED IT ON ROUTER ip nbar protocol-pack bootflash:pp-adv-isr4000-173.1a-40-57.0.0.pack force IT...

I'm trying to find an OID that I can use to monitor the ptp clock offset from the master. For clarification: on a switch I execute the command "sh ptp clock" and it gives me the integer value of the "Offset From Master" and so I need an OID that can ...

Hi, I want to create script to just a copy running-config to tftp server. Or anyone knows command to execute the same task without prompting for input.I am running following command on cisco ASA box.#copy running-config tftp:<IP address>/<director na...

Hello, This should be a simple question. We configured our C9300, C9200, and ISR4331 devices with "Logging trap critical" and sending the logs to a syslog server. When we check the log entries, we find entries pertaining to BPDUs or access port statu...