Greetings, Kindly advise if we can upgrade the mLOM card with additional 10g SFP+ fiber ports as the present hardware having ony 2 dual 1/10G copper ports. I could not any Cisco doc or part number for upgrade interface
Forum Posts
HiI am trying to use Flexible Netflow on Virtual-Access Interfaces which are used by PPPoE subscribers.Solution works fine as far as the PPPoE session is up and accordingly the Virtual-Access Interface is up.The Case is when we have a disconnection f...
Resolved! Dmvpn problem
Hello I have dmvpn between ASR and c800 , with 4 tunnell and ospf protocol . tunnel 0 has ip ospf cost1 , tunnel 1 has cost 5 and so . It is working normally , route is coming from tunnel 0 , but my problem is that when i shutdown tunnel 0 in hub si...
I have a Prime Infrastructure runnung version 3.9.Following scenarion, I do already have scheduled compliance jobs running.If I do changes within the policies or (un)check rules in a already scheduled profile, is that updated in the already scheduled...
I have to clean a configuration on an IOS XR.I explain: I noticed that some parts of the configuration are not used/applied.For instance, DHCP profiles are configured but not applied/linked to an interface. And the same for such ACL.The configuration...
Hi, In a customers PI3.1.4 the 93180 comes up as "not supported device", although it says here that 9K should be supported: http://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-1/user/guide/pi_ug/maint_images.html On the other hand...
Resolved! Cisco FMC dual home internet connection
Hi everyone! I stuck at point, can anyone explain me how to configure Cisco FMC to automatically switch to second Internet channel, when main is down. I have this config route Outside_KTC 0.0.0.0 0.0.0.0 188.127.36.49 5 track 3route Outside 0.0.0.0 0...
Trying to installation the one more box ASR-9K. Help is appreciated. How should I do? And the SecureCRT Said:Key exchange failed.No compatible hostkey. The server supports these methods: Thank you very much.
Resolved! Can IOS do an nslookup?
I have a switch configured to resolve hostnames, it works fine, if I ping xxx.xxx.local or whatever it looks up the IP and displays output.Can this be done in reverse? So If I find an IP address in the arp table and want to resolve its hostname, is t...
Hello, I installed Netflow v9 on an asr1001-x to collect BGP traffic information. But I notice in the monitoring tool that I have as23456 which appears with other ASN 2-byte. After some research, default Netflow exports only 2-byte ASNs in the templa...
Hi, I will install agent on server or workstation to transmit Windows Event log. Also, network switch will send syslog by changing the settings.As shown in the figure below, the problem of IP address duplication may be occurred because each independe...
Hello everyone! Im doing a beginner school project and I need to pick the router, switch, and NAS server for a small business with 6 offices with voip phones and computers and printers, with a wireless access point inside and outside the building. We...
When creating a port channel on Nexus (part of a VPC pair), do you restrict VLANsat both the Ethernet interface *and* the port channel interface? Or just one or the other? Thank you. interface port-channel30switchport mode trunkswitchport trunk allow...
Hello, I sincerely apologize if I asked at the wrong place to post my questions. I am currently having difficulties with implementing QoS in packet tracer. We are tasked to implement Netflow for my routers and the direction I chose to use is from AR1...
Hello guys. I’ll work on somes implementation about PTP Protocol on Nexus Switch.I saw some Cisco Live about Deep Dive of PTP. But however I would ask you some other interesting documents (If you Know) about this protocols: Particularly some Cisco im...
