Hi there, I am new to packet tracer and have been asked to enable a device on my packet tracer lab to be able to access the internet. What would be the best way to go about this and how?
Forum Posts
Hello, I bought a 5506 from Ebay to use a traning purpose. After I received it today, I spent hours configuring to access the internet but I'm still struggling with it. I have a lot of questions but here are some main ones. 1. Is there a way to downl...
We are attempting to configure our FMC front end to allow Common Access Card (CAC) access.At one point we were able to run the test and pull names from the AD server.We are using TLS with a cert.The output from the test has failures:"Failed to issue ...
Hello I have had my email server running for 2 or so years and all reverse/forward dns and PTR records as well as MX and so on and so forth have all been verified and have worked up until my 55008-X crashed and am using my 891f. I have to believe the...
Resolved! router and switches
please what router or switch can I buy to use for ccna and ccnp. preparation because I understand there are 5 kinds of switches and for router i dont know much as at now. suggestions and advise will be appreciated and how many routers and switches ...
I've seen a few videos and docs that describe it being done, but was wondering about those who actually use ACI to day to day in their data centers.We have a fairly mature and stable production ACI system for our intranet server infrastructure, and I...
Hi,is there a chance to catch a guru here to help me filter out some very annoying messages on IOS XE SDWAN sw, that happen on console while vManage does some activity? Cisco TAC responded that he knows about "no logging console" only...ESM got on my...
Resolved! Cisco FPR 1010 Web Interface Access
Hi guys, i have a cisco fpr 1000 series, the default configuration had a bridge interface with a static ip of 192.168.1.1 that contains all the inside ports from 2 to 8, i removed port 3 from that bridge and assigned that port a static ip which is 19...
Hello all,I have strange issue with new WS-C2960-48PST-L switch. When I'm trying add this device to Cisco Network Assistant (v.5.4) community I'm getting status message "Unsupported device type".I install this switch only with basic configuration (se...
Resolved! voice and access VLAN for same Mac
Hi,I'm experiencing some problems with one of our 2960X switches.My voice vlan is 42, my data vlan 40. What is working:- phone gets an DHCP IP in voice vlan- laptop get an DHCP IP in data vlan Whats wrong:When i perform a show mac I get the following...
Hi to All,i have added in Prime some UPS devices , Prime recognises them via the ReadOnly community i have configured to these UPS.I have also configured them to send SNMP taps to Cisco Prime. Is there a way i can view these traps from these devices...
Hi, Having trouble with adding cco credentials under administration/settings/system settings/General/Account Settings in Prime. I want to check if it is due to the lack of internet connection on Prime. How do you check that?
I need to aggregate SPAN ports from multiple network segments into a single switch with uni-direction cable. Example. I have three independent/isolated three networks LAN-A, LAN-B & LAN-C.I need to take SPAN port from all three network and put it int...
Hi everyone, I use netconf to perform some configuration actions. For security reason I prefer to keep netconf turned off by default and only activate for short time. Activation is no problem for me - I do it with ansible.But it would be much easier ...
I'm facing issue in designing network for our machinery. We have 16 No's of machine connected to single UN managed HUB. If HUB failure happens we are facing communication issue and losing our production due to damaged products. Without server communi...
