Hi, dearsHow can i monitor SVI (interface vlan) traffic in ME3600x series with snmp?on ASR 901 there are commands: "vlan-counter egress/ingress" that makes it possible. but how about ME3600x series?IOS version is 15.5(3)S3do you have any suggestions...
We upgraded PI from 3.2 to 3.3. After reboot it fails during "ncs start" with the following error.
Error generating key java.security.KeyStoreException: Could not create new key Could not generate RSA key for SSL
The launchout.log files shows this:
S...
Hello, I just purchased a CISCO RV345P and it's configured and functioning as desired with 1 exception. I have 2 Aruba AP's coming into 2 ports. These devices effectively tag 4 different WLAN's for 4 different VLAN's on the 345. For all these VLAN's....
I have been searching for a way to get the Prime compliance audit feature to look into an ASA and check if only the allowed permit rules are present and nothing more. I was trying to find a way to get Apache VTL to check the output from "show run ac...
Hello,I am having trouble understanding the concept of Static NAT in my environment. There is a Static Bidirectional NAT as follows : Source - 192.168.1.1-10 Destination 10.10.10.1 Translated Source - Same Translated Destination 10.80.25.12...
Hello together, is it possible to install multiple instances of the Smart Manager Satellite, not in HA mode but in parallel into 2 different subnets? They shall connect to the same virtual account in the Cisco DB.Why not HA? I want to install 2 insta...
hello ,i have a problem with copy file from disk:/defaultRepo to one repository that i make in disk:/file .I use from below command :# copy disk:/defaultRepo/VER3.3.0.303.107_BKSZ19G_CPU8_MEM3G_RAM15G_SWAP15G_APP_CK3353207043.tar.gpg ftp://reportsOnD...
Hello! i was just wondering about the appropriate way to connect my devices... What I mean is that I have a 5508-X with 5 Usable Static IPS and each Port is associated with its own IP. 2 of the IP’s, 2 different interfaces, connect to their own Route...
Hello,
I want Prime Infrastructure 3.0 to manage the WLAN/Wifi guest users on a 5508 Wireless Controller.
But i always got an error when adding a new user.
Error(s): You must correct the following error(s) before proceeding:Error:Could not apply th...
Hi,I have a range of devices, but cannot find a single OID that will allow me to pull the serial numbers via SNMP.Can someone please help?I'd like to get for at least these models:2950296035603750PIX515eThanks,Gareth.
Hi FolksI'm looking to enable 2x2 MIMO on the cellular 4G/LTE interface which I believe this router should be able to do, however info is a bit scarce. Its up and running at the moment, however removing the M1/DIV antenna does not slow down the conn...
Hi fellows,I am using 2 cisco 1941 routers, each have separate 500mbps internet link locally located for redundancy.GLBP protocol is running for redundancy on a configured virtual gateway perfectly. My question is that, One router state is "Active" a...
