Network Management

We have just installed a set of 5585 firewalls running multiple virtual contexts. What I want to do is to back up the system context (the other contexts are managed separately) Adding the device in Prime works perfectly and the configuration is back...

Hi, I am thinking of donating my old ASA 5505 but would like to wipe it's brain first, set it back to the original factory settings.  The recipient wants to use it to practice and learn how to configure Cisco gear but I don't want him learning all o...

Hi there! So far at my workplace I'm using Rancid for backups and to push global commands to groups of switches or to all the cisco switches, but that's what so far I know about Rancid. Is there any way that you guys can share the different Scripts...

Is it possible to configure Cisco prime to bounce the switch port if the specific switch port status is connected and CDP detected AP, but, AP is not associated to WLC.  We get alarms in Cisco prime everyday that AP got disassociated. prime will als...

Hi All, After the Last Update to CNA 6.3 i started facing an issue when trying to delete an entry (MAC Address) Under Secure Address in Configure --> Port Security. When i apply the Changes the following error appears: Error: Port Security. String i...

On a Cisco ASR 1006 exporting netflow to a collector,  does the "ip flow-top-talkers top <N>" command control the maximum number of flows exported per interval (e.g. every 60 seconds)?  For example, if my config contains the following: --------------...

On a Cisco ASR 1006 exporting netflow to a collector,  does the "ip flow-top-talkers top <N>" command control the maximum number of flows exported per interval (e.g. every 60 seconds)?  For example, if my config contains the following: --------------...

I'm looking to build a network device provisioning network that's as automated as possible in terms of bringing up a device for the first time and configuring the switch to our baseline config. I have ISE profiling the new devices and assigning them ...

why does #show snmp-server oidlist not show a MIB that can clearly be walked? I have 10 Cisco 5505 Firewalls. All of which are running ASA 9.1.7(4) I can monitor IPSEC tunnel traffic on half of them (as the cikeTunnelEntry can be walked) but the othe...

I'm new to EEM and have this configured on 3925 router.  The intention is to remove pbr if tracking is down and add pbr if tracking is up.  When track 123 is UP, the pbr-on applet doesn't run.  When track 123 is DOWN, the pbr-off applet does run, but...

I have 3 questions regarding Cisco IE 2000: - Can I use Cisco EEM scripting to turn on/off DHCP for all ports (one script would have DHCP turned on, other with DHCP turned off). - Can I/O alarm values be used to trigger the two different EEM scripts ...

Hi All, I could see few posts related to email notification in the support forum, still I have a question related to this  Is it possible to limit the interface down alert to only the selected Port Group, or can the alert be limited only based on de...