SSH Access Segmentation Challenge on ISR4300/IOS-XE 17.12.4a Platform Hardware: ISR4331, ISR4321 (ISR4300 series) Software: IOS-XE 17.12.04a Objective Implement SSH access with two different security policies based on authentication method: Public...
Forum Posts
I have read older postings saying this is not supported, but there are hints that it may be in later versions. I have (for example) a 3850 running 16.12.07.ciscoIetfDhcpv4SrvMIBObjects ( 1.3.6.1.4.1.9.10.102.1) appears to have some of the data, incl...
Hi Guys, Is there any way to download all MIB from IOS XR routers ?
I can't do ping from PC-A and PC-B to interface VLAN 4 of Switch1 and Switch2 by using IPv6 addresses. But same pings with IPv4 addresses are working. What can I do to fix that problem?Pkt file and txt files with configuration of every device are on ...
hello all, i would like to ask you for advice. i would need to send from my devices each hour a syslog message (for example heartbeat_nameofdevice) each hour to Qradar. those devices are nexus 9K (9.3.9) and ASA firewall. i tried to configure it with...
I have run into an issue in our lab which I'm curious how others have dealt with. With more than 1 user logged into the active firewall and issuing commands. The active firewall has the expected config and differentiates the users commands. The comma...
Hey there.Im trying to setup a management VLAN on my Switch downstairs through my ASA thats on my same network but im having the address on another network so its routed through the ASA to harden up SSH to my address only.Some rough config isManageme...
I finally got Nmap on my laptop and trying to get familiar with it. I scanned my my own IP address just to see what's going on. I had the following TCP ports opened:135, 139, 445, 2179, 3389. Is it normal to have these ports opened?
Hi, I am looking to block SNMP from internet on our Cisco 3K switches. The ACL quite not working on interface level and PBR level. RegardsSP
hi.. i'm getting the following error %SWPORT-4-MAC_CONFLICT: Chassis 1 F0: cpp_cp_svr: Dynamic mac B827.EB64.23F0 from GigabitEthernet2 conflict with WlClient, please check the network topology and make sure there is no loop.QFP:0.0 Thread:000 TS:000...
Hi,after a upgrade from xe 3.11.07 to 3.11.09 we cannot open a ssh session to our 4510+R Switch. Before the upgrade everything works fine. The error message in the log is:%SSH-3-BAD_PACK_LEN: Bad packet lenghthWe zeroised the rsa key and generate i...
when i click on web console its give me error 404
Hello, before Christmas Cisco has released Update 2 for Cisco Prime Infrastructure 3.10.4. There is note which I am interested in how one can understand. Here are release notes: https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-10...
Resolved! Difference in iOS versions
Hello!I have two switches, and when I run the Version command one shows:LANBASEK9-M 15.2(1)E2and the other:LANBASEK9-MZ 15.2(1)E2What's the difference between the -M and -MZ? Can these be used together on the same network?Thanks!
